Shop headings: New Spares | Used Spares | Accessories | Brands
Black Magneti Marelli plastic distributor cover for models with points or most electronic ignitions (not Piranha)
See SSA05025 for the screws which secure this dizzie cap
This part is due back in stock soon, call 01484 841395 to reserve yours
14715420 GU14715420 14 71 54 20
1471 5420 1471.5420 14.71.54.20
£21.50
INC VAT
£17.92 EX VAT
Chrome finish plastic horn cover
Sorry, this part is no longer available.
31744765 GU31744765 31 74 47 65
3174 4765 3174.4765 31.74.47.65
Sorry this item is out of production
Mechanical Bosch voltage regulator
- Nominal current: 25 amps - Nominal voltage: 14V - Length: 120 mm - Width: 70 mm - Height: 80 mm
This part is available by special order, request a quote
12703805-z 12703805 GU12703805 12 70 38 05
1270 3805 1270.3805 12.70.38.05
£165.00
INC VAT
£137.50 EX VAT
Complete electronic ignition kit containing alternator mounted ignition pickup, fittings and amplifier unit. Works with 12 volt 3 Ohm coils ELA14500 (big twins) and can be used to replace Digiplex on models with Ducati charging systems where the bike is converted to carburettors. This kit is just an ignition system, it will not control fuelling. The pickups for this kit are mounted on the alternator stator. Supplied with instructions in German with wiring diagrams.
2 year warranty on Sachse ignition kits
Once fitted no further adjustment should be necessary. Preloaded with nine ignition curves, two of which are designed for twin plugged bikes. See this link for fitting instructions. Some bikes may need at least one additional spacer to allow enough clearance for alternator cover to fit once pickup is fitted. Note that if you are replacing a Digiplex system you will also need to replace your 'square' coils with higher impedance 12 volt coils e.g. ELA14500
This part is available by special order, request a quote
£395.00
INC VAT
£329.17 EX VAT
Brand new right hand original "Lego" type switchgear and twistgrip with switches for starter and run/kill.
Previously unavailable new and ideal for your restoration project.
Comes with attached 4 pin molex connector, molex pins and rubber boot, ready to be plugged into your standard loom.
Twistgrip for standard dual throttle cables.
See ELA17061 and ELA14055 for left hand switches.
Sorry, this part is no longer available.
Sorry this item is out of production
Cut out switch, threaded body. Used as sidestand switch on big twins and clutch cut out switch on V7 series small twins and Breva 750
This part is available by special order, request a quote
29759150 GU29759150 29 75 91 50
2975 9150 2975.9150 29.75.91.50
£75.00
INC VAT
£62.50 EX VAT
Lambda sensor with 660mm lead
This part is available by special order, request a quote
896110 MG896110
£121.00
INC VAT
£100.83 EX VAT
Lambda sensor with 325mm lead
This part is available by special order, request a quote
584344 MG584344
£149.00
INC VAT
£124.17 EX VAT
Regulator rectifier with twin plugs, 3 yellow wires to white connector, 4 wires to black connector
This part is available by special order, request a quote
2D000043
£175.00
INC VAT
£145.83 EX VAT
Pair of performance Dyna 12 volt 5 ohm single lead ignition coils with angled HT lead socket. These are a cooler running coil that offer improved starting and performance
Dyna Performance Replacment Coils are high tech, top quality coils, designed for maximum performance. They produce spark voltages in excess of 30,000 volts and spark energies second to none. Dynatek coils are available in a wide variety of resistances and output configurations to allow easy replacement of stock coils. Dynatek coils work with factory electronic ignitions, points, and aftermarket ignitions.
These are a different size and shape from the original coils so you will need to fabricate a suitable coil mount.
Individual coils available by special order, call us for details. See ELA00001 for crimp on HT lead connector
This part is due back in stock soon, call 01484 841395 to reserve yours
1471650
£190.00
INC VAT
£158.33 EX VAT