50cm Ariete fuel or breather pipe suitable as fuel pipe on gravity fed non injection models

Certified ethanol proof and safe for modern E10 fuel. Hose clips also available, see FUA00004

 This part is due back in stock soon, call 01484 841395 to reserve yours

Pod type air filter for increased air flow

Made from a high performance twin layer foam this K & N type air filter is designed to offer improved and unrestricted airflow whilst offering adequate filtration. Washable and reusable (use hot soapy water). Best run dry for road. Fits VHB 29, VHB 30, PHBH28 and PHBH30 Dellorto carbs. You may find that a 5-10% increase in main jet size helps to make the most of the increased air flow with this filter

 This part is available by special order, request a quote

Pod type air filter for increased air flow

Made from a high performance twin layer foam this K & N type air filter is designed to offer improved and unrestricted airflow whilst offering adequate filtration. Washable and reusable (use hot soapy water). Best run dry for road. Fits PHF 30 and PHF 36 Dellorto carbs. You may find that a 5-10% increase in main jet size helps to make the most of the increased air flow with this filter

 This part is available by special order, request a quote

Long (right hand) choke cable

We advise you to measure your existing cable before ordering in case you have a non standard set up.

 This part is due back in stock soon, call 01484 841395 to reserve yours

 17133560 GU17133560 17 13 35 60
 1713 3560 1713.3560 17.13.35.60

Aluminium inlet reduction sleeve. Threaded at smaller end

 Sorry, this part is no longer available.

 29114400 GU29114400 29 11 44 00
 2911 4400 2911.4400 29.11.44.00

Plastic inlet manifold, replaces unavailable aluminium manifold. Suitable for PHF 30 carb conversions on models previously fitted with VHB30 carbs. Contains inlet manifold, gasket, O rings, clip and M6 bolts to secure to head. Carb mounts direct to this manifold (no inlet manifold rubber required)

Note that on models with M8 inlet manifold bolts and standard heads (T3, 1000 SP) it will be necessary to drill out the manifold bolt holes from 6mm to 8mm to reuse your existing bolts. Can be used to replace PHF30 inlet manifolds 17116265 and 17116365 which are no longer available. These manifolds exit the heads at a different angle to VHB manifolds and in some cases you may need to modify side panels to allow clearance for air filters

 This part is due back in stock soon, call 01484 841395 to reserve yours

Single fuel union or banjo for Dellorto carb

See FUA60888 for fuel union filters

 Availability varies on this part, check availability

 13934600 GU13934600 13 93 46 00
 1393 4600 1393.4600 13.93.46.00