Full engine and gearbox seal kit, includes all necessary seals for a complete engine and gearbox overhaul.

Full gasket sets also available. Can also be fitted to models equipped with a Saprisa charging system if front crank oil seal ENA94238 is ordered

 2 in stock

 17999550 GU17999550 17 99 95 50
 1799 9550 1799.9550 17.99.95.50

Swing arm pivot stub, metric fine thread. See TRA92780 for cover nuts. Replaces Guzzi ref. 14547000

 2 in stock

 14547001 GU14547001 14 54 70 01
 1454 7001 1454.7001 14.54.70.01

5 pin 12 volt relay suitable for starter, lights, indicator, flasher and horn applications

Supercedes Guzzi ref. 12732500. Equivalent to 28732500 but with mounting bracket

 5 in stock

19732500-z 19732500 GU19732500 19 73 25 00
 1973 2500 1973.2500 19.73.25.00

Needle roller bearing for crownwheel

 1 in stock

 92254340 GU92254340 92 25 43 40
 9225 4340 9225.4340 92.25.43.40

The BoosterPlug is an effective and cost efficient way to cure the fuelling problems common to all modern fuel injected Guzzi's.
Plugging directly into the wiring harness using original connectors, with no cutting or splicing required, installation takes less than ten minutes.

The BoosterPlug features a unique technology to provide your bike with a controlled fuel enrichment in all ambient temperature situations. No other Plug and Play device does this. A richer mixture is provided only when needed i.e at low RPMs and when accelerating. On open roads at a constant speed the Boosterplug sits idle to keep fuel consumption low.
Make your bike run as it should have done from the factory!

• Improved and gentler throttle action when opening and closing throttle
• Richer mixture when opening the throttle improves acceleration
• Booster plug removes the uneven low speed running that is typical for modern lean burn engines
• Stronger and more consistent at idle.
• Reduced backfiring with aftermarket exhausts on engine braking
• Lifetime warranty

 This part is due back in stock soon, call 01484 841395 to reserve yours

Full service kit containing 1 x UFI oil filter, 1 x UFI air filter, 2 x NGK BP6ES spark plugs, 1 x sump gasket, 2 x rocker cover gaskets and all crush washers to complete a service on your round barrel model with electronic ignition.

Save time and hassle by ordering service oil kit OIA14001 with your service kit

Save £'s by buying everything in a service kit

For models with points see SIA14001, if you have a deep sump you'll need an extra sump gasket (ENA14036). Oils and lubricants available separately. The oils you need are 1 x OIA11036 and 1 x OIA08194. See ENA95006 for gauze oil filter tab washer

 More than 5 in stock

Full service kit containing 1 x UFI oil filter, 2 x NGK BP7ES spark plugs, 1 x sump gasket, 2 x rocker cover gaskets and all crush washers to complete a service on your round barrel Le Mans with electronic ignition.

Save time and hassle by ordering service oil kit OIA14001 with your service kit

Save £'s by buying everything in a service kit

For models with points see SIA14003, if you have a deep sump you'll need an extra sump gasket (ENA14036). Oils and lubricants available separately. See ENA95006 for gauze oil filter tab washer. The oils you need are 1 x OIA11036 and 1 x OIA08194

 More than 5 in stock

Full service kit for pre PI engine EV models containing 1 x UFI oil filter, 1 x UFI air filter, 2 x NGK BPR6ES spark plugs, 1 x sump gasket, 2 x rocker cover gaskets, O ring and all crush washers to complete a service on your bike

Save £'s by buying everything in a service kit

See FUA29106 for fuel filter, ENA95006 for gauze oil filter tab washer. Oils and lubricants available separately. The oils you need are 1 x OIA01152 and 1 x OIA08194 or save time and money by ordering service oil kit OIA18004 with your service kit.

 1 in stock

Rocker cover screw kit containing 16 replacement stainless steel socket cap bolts for round and square barrel engine rocker covers. Only one kit required per engine

To ensure you can easily release these fasteners in years to come we recommend wiping each fastener with copper grease (OIA11070). This kit is for models without billet rocker cover protectors fitted, for models with rocker cover protectors see SSA80015. This kit will suit a V11 with standard rocker cover protectors which are much thinner than aftermarket types.

See SSA81522 for rocker cover trim retaining screws on 2v/cyl CARC models, these are not included with this kit.

 More than 5 in stock

Full drive box seal kit and gasket set for overhauling the rear drive box

For Breva 750 from frame no. LL111908.

Bearings available separately

 1 in stock