The BoosterPlug is an effective and cost efficient way to cure the fuelling problems common to all modern fuel injected Guzzi's.
Plugging directly into the wiring harness using original connectors, with no cutting or splicing required, installation takes less than ten minutes.

The BoosterPlug features a unique technology to provide your bike with a controlled fuel enrichment in all ambient temperature situations. No other Plug and Play device does this. A richer mixture is provided only when needed i.e at low RPMs and when accelerating. On open roads at a constant speed the Boosterplug sits idle to keep fuel consumption low.
Make your bike run as it should have done from the factory!

• Improved and gentler throttle action when opening and closing throttle
• Richer mixture when opening the throttle improves acceleration
• Booster plug removes the uneven low speed running that is typical for modern lean burn engines
• Stronger and more consistent at idle.
• Reduced backfiring with aftermarket exhausts on engine braking
• Lifetime warranty

 This part is due back in stock soon, call 01484 841395 to reserve yours

Small stainless steel hose clip for fuel, oil and small breather pipe unions. Suitable for fuel injection hoses

 More than 5 in stock

Black phase sensor O ring

Also known as Guzzi ref. 847180 timing sensor o ring

 More than 5 in stock

 90706141 GU90706141 90 70 61 41
 9070 6141 9070.6141 90.70.61.41

UFI 30 989 00 flat type air filter, paper filament in rubber surround

See SIA30361 for a reusable K & N air filter

 More than 5 in stock

 30113600 GU30113600 30 11 36 00
 3011 3600 3011.3600 30.11.36.00

Single 100cm length of neoprene rubber pipe used for oil breather applications depending on model. Can be used as fuel pipe on carb bikes. Also see FUA00011 as alternative for this pipe

Use hose clip FUA00004

 More than 5 in stock

Crush washer with various uses including fuel system and oil pump depending on model

 More than 5 in stock

 18161150 GU18161150 18 16 11 50
 1816 1150 1816.1150 18.16.11.50

UFI 31 504 00 fuel filter, threaded connections, includes copper washers. See FUA29107 for alternative filter from Mahle

Replace every 6000 miles. Replaces Guzzi refs. 29106060 and 29999660. Only for series 1 Daytona 1000. Will not fit early Cali 3s which have filters with two 14mm threads.

 5 in stock

 29106061 GU29106061 29 10 60 61
 2910 6061 2910.6061 29.10.60.61

High pressure black fuel line / fuel line

Also known as Guzzi ref. 008239520800, 00823941078, GU00823952080. This high pressure fuel hose is rated to 10 Bar. Also see FUA80000 of a Y shaped connector or FUA80001 for a T shaped fuel line connector. R7 spec. E5 and E10 ethanol resistant

 5 in stock

823952080

High pressure black fuel line / fuel line, can be used to replace fuel line on other models with 6mm ID fuel lines

This high pressure fuel hose is rated to 225 PSI. It has been designed for use with Modern Chemically Aggressive Bio-Ethanol Enriched Petrol Formulations (E5 & E10) As per currently served petrol pump petrol. Confirms to SAE J30 R7 and BS AU 108. See FUA00004 for hose clips

 5 in stock

AP8144069

Single T-shaped nylon fuel pipe connector for 6mm ID fuel pipe or breather pipe

 5 in stock