Shop headings: New Spares | Used Spares | Accessories | Brands
Dimensions:
M10 single banjo fine thread
Universal hydraulic brake light switch. This hydraulic switch replaces discontinued brakelight switches by bolting in place of a single banjo bolt on the handlebar or rear brake master cylinder
NB may be supplied with or without 2 pin block connector.
2 in stock
£24.50
INC VAT
£20.42 EX VAT 
Full engine seal kit, includes all necessary oil seals for a complete engine overhaul
Full gasket sets also available, see ENA10001
Dimensions:
120mm x 10mm stem, 40mm OD head
Exhaust valve
10036100 GU10036100 10 03 61 00
1003 6100 1003.6100 10.03.61.00
£25.00
INC VAT
£20.83 EX VAT
Dimensions:
120mm x 10mm stem, 47mm OD head
Inlet valve
10036000 GU10036000 10 03 60 00
1003 6000 1003.6000 10.03.60.00
£25.00
INC VAT
£20.83 EX VAT
Replacement pannier to frame lock for all Hepco and Becker panniers. This is the lock at the rear of the panniers that secures it to the pannier frame plate
Supplied with key, lock plate, rivets and fitting instructions. Includes pannier frame plate LUA70114
£25.20
INC VAT
£21.00 EX VAT
"The Carburettor Manual" is a comprehensive guide from Dellorto to the setting up and use of tapered needle motorcycle carburettors. Covers principle of operation of all Dellorto tapered needle carburettors 1970 onwards. 33 pages with colour pictures and diagrams. Also included is the original Dellorto "Tuning Guide 1.1" for carburettors, which gives advice on the choice, setting and use of a Dellorto tapered needle carburettor which includes colour carburettor cross sections showing the multiple stages of carburettor operation. Also contains float height and tapered needle selection tables.
5 in stock
£22.00
(VAT exempt)
£22.00 EX VAT
Replacement lock for Hepco and Becker Junior panniers and top boxes / top cases. This is the lock at the top of the panniers. Also used as the closing lock on Junior top boxes LUA61040 and LUA61045
Supplied with key, rivets and fitting instructions
1 in stock
£27.00
INC VAT
£22.50 EX VAT
Dimensions:
M10 conventional thread, 120mm diameter head, 210mm reach to edge of mirror
Left hand chome mirror, especially suited to T3, V50 and similar models. Flat lens.
M10 thread
1 in stock
£27.60
INC VAT
£23.00 EX VAT
Dimensions:
M10 conventional thread, 120mm diameter head, 210mm reach to edge of mirror
Right hand chome mirror, especially suited to T3, V50 and similar models. Flat lens.
M10 thread
1 in stock
£27.60
INC VAT
£23.00 EX VAT
Dimensions:
720mm wide, 40mm rise, 22mm OD, knurled sections have 100mm centres and are 20mm wide
Pair of universal chromed handlebars, low rise
Not suitable for V65 GT, Mille GT or other models with wide handlebar clamps. Note wide spacing of knurled sections sits outside handlebar clamps on T3, V50 etc... - see dimensions if in doubt about suitability for your bike
1 in stock
£27.60
INC VAT
£23.00 EX VAT
Secure online shopping 
