Shop headings: New Spares | Used Spares | Accessories | Brands
This section contains fuel pipes, carb overhaul kits, carb and injection system spares, fuel filters and inlet rubbers
The BoosterPlug is an effective and cost efficient way to cure the fuelling problems common to all modern fuel injected Guzzi's.
Plugging directly into the wiring harness using original connectors, with no cutting or splicing required, installation takes less than ten minutes.
The BoosterPlug features a unique technology to provide your bike with a controlled fuel enrichment in all ambient temperature situations. No other Plug and Play device does this. A richer mixture is provided only when needed i.e at low RPMs and when accelerating. On open roads at a constant speed the Boosterplug sits idle to keep fuel consumption low.
Make your bike run as it should have done from the factory!
This part is available by special order, request a quote
£129.00
INC VAT
£107.50 EX VAT
Small stainless steel hose clip for fuel, oil and small breather pipe unions. Suitable for fuel injection hoses
More than 5 in stock
£1.70
INC VAT
£1.42 EX VAT
Black phase sensor O ring
Also known as Guzzi ref. 847180 timing sensor o ring
More than 5 in stock
90706141 GU90706141 90 70 61 41
9070 6141 9070.6141 90.70.61.41
£2.00
INC VAT
£1.67 EX VAT
Air filter, flat paper cartridge type
See SIA10433 for a reusable K & N air filter
More than 5 in stock
AP8104329
£10.50
INC VAT
£8.75 EX VAT
Single T-shaped nylon fuel pipe connector for 6mm ID fuel pipe or breather pipe
5 in stock
£3.60
INC VAT
£3.00 EX VAT
Single 100cm length of neoprene rubber pipe used for oil breather applications depending on model. Can be used as fuel pipe on carb bikes. Also see FUA00011 as alternative for this pipe
Use hose clip FUA00004
3 in stock
£7.00
INC VAT
£5.83 EX VAT
The Mistral V-Twin boost is an effective and cost efficient way to cure the fuelling problems common to all modern fuel injected Guzzi's. The V85 TT runs particularly lean and will benefit more than most bikes from the installation of a V-Twin Boost.
Plugging directly into the wiring harness using original connectors, with no cutting or splicing required, installation takes less than ten minutes.
The V-Twin boost features a unique technology to provide your bike with a controlled fuel enrichment.
Make your bike run as it should have done from the factory!
1 in stock
£115.00
INC VAT
£95.83 EX VAT
50cm Ariete fuel or breather pipe suitable as fuel pipe on gravity fed non injection models
Certified ethanol proof and safe for modern E10 fuel. Hose clips also available, see FUA00004
1 in stock
£3.00
INC VAT
£2.50 EX VAT
HIgh performance aluminium velocity stack for airbox to throttle body union. This velocity stack replaces the standard part with an aluminium part that protrudes into the airbox. Through careful design it improves the engine response by providing an increased volume of less turbulent air to the throttle body. No modifications are required to fit this velocity stack but you should see a torque increase of around 6% at 2500 RPM and 3% increase in power at 6500 RPM
This manifold is suitable for EURO 4 and 5 models, manufactured on the shores of Lake Como. Developed for optimum power and torque on Mistral's rolling road. For best results combine with a performance air filter - SIA10433 and V-Twin Boost - ACA85001 or ACA85002.
Customer Kev fitted this combo and called us the next day to say that his V85TT was transformed; the fluffy throttle response between 2k and 3k was gone and the engine pulled better. Simple to fit, installation time is less than 30 minutes and the battery does not need to be disconnected.
1 in stock
£140.00
INC VAT
£116.67 EX VAT
K&N high performance air filter, flat paper cartridge type
This part is due back in stock soon, call 01484 841395 to reserve yours
AP8104329
£54.00
INC VAT
£45.00 EX VAT