The Mistral V-Twin boost is an effective and cost efficient way to cure the fuelling problems common to all modern fuel injected Guzzi's.
Plugging directly into the wiring harness using original connectors, with no cutting or splicing required, installation takes less than ten minutes.
The V-Twin boost features a unique technology to provide your bike with a controlled fuel enrichment.
Make your bike run as it should have done from the factory!

• Quick and easy installation
• Resistant to atmospheric agents and vibrations
• Optimized by Mistral for your bike
• Best response to the opening of the throttle
• Better torque at low-medium range
• Reduction of the on/off effect
• Correct air/fuel ratio in all conditions with real-time modification

 This part is available by special order, request a quote

TPS for throttle body

On Cali 1100 check which TPS you have (varies according to ECU)

 This part is available by special order, request a quote

 01530500 GU01530500 01 53 05 00
 0153 0500 0153.0500 01.53.05.00

Opening throttle cable

We advise you to measure your existing cable before ordering in case you have a non standard set up

 This part is available by special order, request a quote

 978381 MG978381

Closing throttle cable

We advise you to measure your existing cable before ordering in case you have a non standard set up

 This part is available by special order, request a quote

 978382 MG978382

Throttle cable, used for opening and closing throttle

Two cables required per bike. We advise you to measure your existing cable before ordering in case you have a non standard set up.

 2 in stock

 03117545 GU03117545 03 11 75 45
 0311 7545 0311.7545 03.11.75.45

Throttle cable with 90° adapter and adjuster

Only one cable required. If your bike is has plastic switchgear and a single cable it may have been subject to a factory recall which uses our cable CAA03831, see CaliEVThrottleCableRecall.pdf for details.

We advise you to measure your existing cable before ordering in case you have a non standard set up.

 1 in stock

03117500-z 03117500 GU03117500 03 11 75 00
 0311 7500 0311.7500 03.11.75.00

Throttle cable

Only one cable required. If your bike is has plastic switchgear and a single cable it may have been subject to a factory recall which uses our cable CAA03831, see CaliEVThrottleCableRecall.pdf for details.

We advise you to measure your existing cable before ordering in case you have a non standard set up.

 This part is due back in stock soon, call 01484 841395 to reserve yours

 03117530 GU03117530 03 11 75 30
 0311 7530 0311.7530 03.11.75.30

Closing throttle cable for models affected by the 2002 factory recall, for details see CaliEVThrottleCableRecall.pdf

Affected models are: California EV: frame numbers from KD100548 to KD115984, California Special: frame numbers from KD130001 to KD131984, California Jackal: frame numbers from KD150001 to KD153177.We advise you to measure your existing cable before ordering in case you have a non standard set up.

 This part is available by special order, request a quote

 03117830 GU03117830 03 11 78 30
 0311 7830 0311.7830 03.11.78.30

Rubber used to link airbox to inlet tube FUG30560 behind throttle body

 This part is available by special order, request a quote

 30114660 GU30114660 30 11 46 60
 3011 4660 3011.4660 30.11.46.60

Oil temperature sensor

See ELA03330 for sensor support

 1 in stock

 29724961 GU29724961 29 72 49 61
 2972 4961 2972.4961 29.72.49.61