12V 30A 4 pin relay

Various uses including ignition, fuelling and starter relay

 1 in stock

AP8224462

6 pin female block connector, used for main loom connections. See ELA30000 for male 6 pin connector

 3 in stock

200073021

6 pin male block connector, used for main loom connections. See ELA30001 for female 6 block connector.

 1 in stock

200073020

Speedo sensor on ABS equipped models, used for front and rear applications depending on model

Used as rear wheel ABS sensor on V85TT, front and rear sensor on V7 II ABS equipped models. There are several variants of these sensors, please compare to the sensor on your bike or contact us with a chassis number before ordering. Supercedes Guzzi ref. 6429875. 2 pin connector

 This part is due back in stock soon, call 01484 841395 to reserve yours

 859792 MG859792

Self adhesive cable tie block for securing cables to bodywork and panels, particularly useful where cables must be kept out of the way under the rear mudguard. Simply stick block to bodywork, route cable tie through bracket on block and round wiring

Wiring clip. One block

 More than 5 in stock

Domino left hand switchgear with lights on - park - off, high and low beam, pass, indicator and horn switches. Same style switch as ELA01738.

Already wired in to 9 pin block connector (you may need to alter the wiring on your bike to correspond to this block connector). Originally fitted as standard to early V11 Sport models. See the wiring diagram on our technical documents page for help installing this switchgear. See Greg Bender's website for a custom sub-loom that enables easy fitting of this part to models previously fitted with LEGO style swithgear

 This part is due back in stock soon, call 01484 841395 to reserve yours

 01738030 GU01738030 01 73 80 30
 0173 8030 0173.8030 01.73.80.30

Insulated medium female bullet connector

Crimp type

 More than 5 in stock

Insulated large female spade connector for 9.5mm male terminals

Crimp type

 More than 5 in stock

Insulated medium female spade connector for 6.3mm male terminals

Crimp type

 More than 5 in stock

Factory heated grip kit to keep your hands toastie warm all year round. Three heat levels, integrates with the V85 TT wiring and TFT dashboard. The grips are switched on by a button on the left hand switchgear. Fully compatible with fly by wire (unlike aftermarket grips).

Includes a complete heated twistgrip, heated grip for the clutch side and fitting instructions. The thottle has to be calibrated at an official Moto Guzzi dealer with the factory software after installation.

 This part is available by special order, request a quote

2S001325