Smarten up the rear of your V7 with this fenda eliminator kit with includes an LED tail light.

This tail tidy is part of the exciting range of MAS parts to make your V7 stand out from the crowd. Please note that these items are custom made in Italy and normally available to special order with a delivery time of approximately 6 weeks

 2 in stock

One piece collet for exhaust manifold, one required per cylinder

No longer in production

 3 in stock

 14121200 GU14121200 14 12 12 00
 1412 1200 1412.1200 14.12.12.00

Dellorto needle valve kit comprising of valve and felt washer

200 needle valve for VHB24, VHB26 and PHBH carbs

 5 in stock

 19934600 GU19934600 19 93 46 00
 1993 4600 1993.4600 19.93.46.00

Manual square bodied fuel tap with nut, washer and filter

Off, on and reserve positions. Approved for use with fuel containing ethanol

 2 in stock

14105400-z 14105400 GU14105400 14 10 54 00
 1410 5400 1410.5400 14.10.54.00

44mm inlet valve

Also known as Guzzi ref. 03036000

 3 in stock

 14036050 GU14036050 14 03 60 50
 1403 6050 1403.6050 14.03.60.50

37mm exhaust valve

Also known as Guzzi ref. 03036100

 3 in stock

 14036150 GU14036150 14 03 61 50
 1403 6150 1403.6150 14.03.61.50

8 sided UFI 23 287 00 cartridge oil filter with sealing rubber.

From late 2015 onwards 1200 models used SIA06428

See SIA15301 for alternative filter from Mahle. Please note that Daytona 1000 models where filter screws into base of sump require SIA14530. This is a 8 sided oil filter. Use tool TOA41006 if your filter is located inside the sump, use tool TOA01201 if you change your oil filter without removing the sump



See ENA90948 for the oil filter cover o ring

 More than 5 in stock

 30153000 GU30153000 30 15 30 00
 3015 3000 3015.3000 30.15.30.00

Complete cast side stand with springs, pivot and mounting bracket finished in black. This stand is the original flip up / self retracting type

Bolts to engine mounting bolt at front of lower framerail, check that you have a long enough front engine mounting bolt for this sidestand to fit on to. This can be fitted to other Tonti frame models (e.g. Le Mans 1000). See FRA28162 for bracket that enables this stand to be mounted near the rider's footrest using the gearbox mounting bolt.

 1 in stock

17432060-z 17432060 GU17432060 17 43 20 60
 1743 2060 1743.2060 17.43.20.60

Tool for clutch centre gear nut

Half inch socket drive. This is a cheaper aftermarket tool- see TOA14903 for original factory item

 1 in stock

 14912603 GU14912603 14 91 26 03
 1491 2603 1491.2603 14.91.26.03

Throttle cable for models with plastic twistgrip and switchgear

Only suitable for post 1979 models. We advise you to measure your existing cable before ordering in case you have a non standard set up.

 4 in stock

 18117560 GU18117560 18 11 75 60
 1811 7560 1811.7560 18.11.75.60