Mesh silencer gasket, silencer bush or muffler gasket shim for exhaust joint between silencer and downpipe
2 exhaust bushes required per bike
2 in stock
2B007137
£9.00
INC VAT
£7.50 EX VAT
Right hand long choke cable
We advise you to measure your existing cable before ordering in case you have a non standard set up.
1 in stock
19133560 GU19133560 19 13 35 60
1913 3560 1913.3560 19.13.35.60
£6.50
INC VAT
£5.42 EX VAT
Pair of taper roller steering head bearings with separate seals, this is an upgrade to the standard ball bearing races which is less expensive than the OE parts
1 kit required per bike
1 in stock
AP8110077
£78.00
INC VAT
£65.00 EX VAT
Complete rear brake disc for spoked wheel
Always replace brake pads when fitting new brake discs, see BRA89505 for disc bolts
1 in stock
887448 MG887448
£59.00
INC VAT
£49.17 EX VAT
Splined tool for aligning clutch plates on reassembly, without this clutch alignment tool you risk damaging the intermediate plate. The tool screws into the back of the crankshaft to compress the clutch springs and align the clutch friction plates
Suitable only for later clutch centre spline type (e.g. clutch plate CLA05430). As used by the Gutsibits spanner monkeys on their bikes
1 in stock
30906510 GU30906510 30 90 65 10
3090 6510 3090.6510 30.90.65.10
£110.00
INC VAT
£91.67 EX VAT
Uprated double row cam chain, ideally fit with sprung chain tensioner ENA20071
1 in stock
28058060 GU28058060 28 05 80 60
2805 8060 2805.8060 28.05.80.60
£54.00
INC VAT
£45.00 EX VAT
Kit of 8 frame and footpeg caps to finish off your V100. The kit, made of plastic material resistant to UV rays and heat, was developed specifically for the Moto Guzzi V100. It consists of 6 footrest caps and 2 frame caps, covering both the right and left sides. The frame caps are finished with a Moto Guzzi eagle emblem in keeping with the branding elsewhere on the V100. These frame caps tidy the side profile of your machine and prevent water and road spray getting into the frame.
Note that the included M10 washer is required to space the gear lever so it is clear of the installed plugs. Scan the QR code on the box for a short video guide to installation.
1 in stock
£26.00
INC VAT
£21.67 EX VAT
UFI 30 989 00 flat type air filter, paper filament in rubber surround
See SIA30361 for a reusable K & N air filter
More than 5 in stock
30113600 GU30113600 30 11 36 00
3011 3600 3011.3600 30.11.36.00
£12.00
INC VAT
£10.00 EX VAT
One metre of copper core HT lead, this is superior to the more commonly available carbon core lead
Sold by the metre, one metre is enough for two leads on most models with coils under the fuel tank. For models with coils under the side panel you will need two metres. See ELA14715 and ELA14714 for plug caps and ELA20001 for coil screw cap. See ELA00001 for crimp on HT lead connector
More than 5 in stock
£6.40
INC VAT
£5.33 EX VAT