Throttle cable, one ball end

We advise you to measure your existing cable before ordering in case you have a non standard set up

 1 in stock

12607500-z 12607500 GU12607500 12 60 75 00
 1260 7500 1260.7500 12.60.75.00

Set of leads for batter charging. Ring terminals for battery, 2 pin connector for charger to plug into. Often required if you charge more than one bike using your Motobatt Smart Charger

 2 in stock

6 volt single lead ignition coil for Lucas Rita ignition

Includes coil clamp. HT lead screws into this coil

 2 in stock

Modern solid state electronic regulator for models with Bosch charging system

Bolts to original mounting point but this replacement part is not as tall as the old metal regulator. Also known as Guzzi ref. 17703800. Replaces ELA29704

See our Bosch fault finder page for help diagnosing problems on your Bosch charging system. The original type mechanical regulator is no loger available

 3 in stock

29703800-z 29703800 GU29703800 29 70 38 00
 2970 3800 2970.3800 29.70.38.00

Replacement alternator rotor for Bosch systems

See ELA17400 for matching stator and TOA14008 for rotor removal tool. We recommend changing the timing cover oil seal ENA90428 when changing the rotor. Also fits Yamaha RD350, FZR1000 and 1000 Fazer. Note that new rotors may need energizing, see our faultfinder for details.

 2 in stock

Also fits Benelli 900 Sei (Series 2)

K&N high performance air filter, flat paper cartridge type for single throttle body models

• High Air Flow with Excellent Filtration
• Designed to Increase Horsepower and Acceleration
• Washable and Reusable
• Will NOT Void Vehicle Warranty
• Lasts up to 50,000 miles before cleaning is required depending on driving conditions
• K&N Million Mile Limited Warranty�
• Emissions Legal
• Economical, a K&N Air Filter Will Last the Life of Your Bike
• Works with Original Equipment Manufacturer Vehicle Electronics
• Easy High Performance Add-on
• Environmentally Friendly

 1 in stock

AP8104924

5 pin 12 volt relay suitable for starter, lights, indicator, flasher and horn applications

Supercedes Guzzi ref. 12732500. Equivalent to 28732500 but with mounting bracket

 More than 5 in stock

19732500-z 19732500 GU19732500 19 73 25 00
 1973 2500 1973.2500 19.73.25.00

New type clutch friction plate for models with deep splines with deep splined centre

2 plates required- thicker side of each friction plate should face transmission.
Also known as Guzzi ref. 30084410, 03084400, 29084450
V11 Tenni, Rosso Mandello and Scura have a single plate clutch which uses a different friction plate (unfortunately out of production)

These can be fitted to earlier 850 and 1000 models if the early shallow splined clutch centre is replaced with the later deep splined type. See our kit CLA20302 to update early 850/1000 models. Clutch plate alignment tool also available, see TOA30510

 4 in stock

 05084430 GU05084430 05 08 44 30
 0508 4430 0508.4430 05.08.44.30

New type clutch friction plate for models with deep splines with deep splined centre

2 plates required- thicker side of each friction plate should face transmission.
Also known as Guzzi ref. 30084410, 03084400, 29084450
V11 Tenni, Rosso Mandello and Scura have a single plate clutch which uses a different friction plate (unfortunately out of production)

These can be fitted to earlier 850 and 1000 models if the early shallow splined clutch centre is replaced with the later deep splined type. See our kit CLA20302 to update early 850/1000 models. Clutch plate alignment tool also available, see TOA30510

 4 in stock

 05084430 GU05084430 05 08 44 30
 0508 4430 0508.4430 05.08.44.30

Pair of EBC FA181TT rear brake pads

Also known as Guzzi ref. 30654626

 More than 5 in stock

05654630-z 05654630 GU05654630 05 65 46 30
 0565 4630 0565.4630 05.65.46.30

Also fits Royal Enfield Himalayan (Front)