Oil pressure sender
Can also be used in place of oil pressure switch 17768750 and adapter 19055800 on Monza (check which type your small twin uses before replacing). Replaces two part sensor 31999581.
See ENA12640 for replacement crush washer if required
5 in stock
19768720-z 19768720 GU19768720 19 76 87 20
1976 8720 1976.8720 19.76.87.20
£15.50
INC VAT
£12.92 EX VAT
Oil pressure sender, M12 thread, male bullet connector
Supercedes Guzzi no. 12768700. Some small twins also require adapter 19055800 (or ELA19720 can be fitted in place of this switch). Check which type your small twin uses before replacing.
See ENA12640 for replacement crush washer if required
More than 5 in stock
17768750 GU17768750 17 76 87 50
1776 8750 1776.8750 17.76.87.50
£10.00
INC VAT
£8.33 EX VAT
Silencer clamp gasket / shim or muffler gasket used to seal crossover to silencer
This exhaust bush is not required if a Mistral or Agostini silencer is fitted
1 in stock
05128230 GU05128230 05 12 82 30
0512 8230 0512.8230 05.12.82.30
£25.00
INC VAT
£20.83 EX VAT
Rear crankcase oil seal or rear main oil seal.
Fits Nevada 750 up to engine LT017877 and Nevada 350 to engine PC053625. Also known as Guzzi ref. 90405368. We recommend replacing the rear crank oil seal when replacing the clutch
More than 5 in stock
90405367-z 90405367 GU90405367 90 40 53 67
9040 5367 9040.5367 90.40.53.67
£14.00
INC VAT
£11.67 EX VAT
UFI 25 46 500 cartridge oil filter. See TOA19001 for a inexpensive tool to loosen and tighten the dipstick
For post 1989 V35, V50 and V65 models use SIA27300 .
NB Packaging may vary. For an oil change we also recommend 1x ENA90444 (Oil filter cover O ring), 1 x SIA10070 (large sump drain crush washer), 1 x SIA10900 (small sump drain crush washer) and 1 x SIA12200 (filter cover crush washer)
More than 5 in stock
19153000 GU19153000 19 15 30 00
1915 3000 1915.3000 19.15.30.00
£8.50
INC VAT
£7.08 EX VAT
Head Gasket
5 in stock
30022060 GU30022060 30 02 20 60
3002 2060 3002.2060 30.02.20.60
£14.40
INC VAT
£12.00 EX VAT
Clutch cable
We advise you to measure your existing cable before ordering in case you have a non standard set up
1 in stock
2B001202
£23.00
INC VAT
£19.17 EX VAT
Ducati type alternator stator
300W output, doesn't include rotor / magnet. Also known as Guzzi ref. 30712460
1 in stock
37712405 GU37712405 37 71 24 05
3771 2405 3771.2405 37.71.24.05
£210.00
INC VAT
£175.00 EX VAT
Single stainless steel M10 banjo bolt with bleed nipple for Brembo fittings. Supplied with bleed nipple cap and crush washers. Perfect for bleeding up old P9, F08 and F05 calipers where the bleed nipple has broken off. This can also be used to add additional bleed points to linked systems where airlocks are causing problems
These can be used to replace the standard banjo bolt on CARC models. See alternative part BRA41653 for Stahlbus auto bleed banjo bolt
More than 5 in stock
Also fits Benelli 250 TS
£21.00
INC VAT
£17.50 EX VAT