Halogen headlight bulb H1 12V 55W. Used for main beam.

Also known as Guzzi ref. 30530557

 1 in stock

 580141 MG580141

Universal hydraulic brakelight switch. This hydraulic switch replaces discontinued brake light switches by bolting in place of a double banjo bolt on the handlebar or rear brake master cylinder

Especially suitable for replacing the standard switch on models where the front brakes have been 'de-linked'

 1 in stock

Round 12v two pin flasher relay with warning buzzer, reduces risk of indicators being left on.

Includes mounting rubber

 1 in stock

 17750520 GU17750520 17 75 05 20
 1775 0520 1775.0520 17.75.05.20

Timing sensor for ignition and tacho

3 pin block connector. Used on models with the smaller 15M ECU

 Order now and we will post your order within 7 days.

 01721600 GU01721600 01 72 16 00
 0172 1600 0172.1600 01.72.16.00

Left hand Domino type switchgear with high and low beam, pass, indicator and horn switches. Same style switch as ELA01738

On most bikes this will not plug directly into the wiring loom, you will need to match the wires to your loom. An indication of wire colours is supplied with this switchgear. Supplied with 9 pin block connector. NB does not have lights off - park - on function, you need this to be on your RH switch (e.g. ELA01729 ) or run lights always on

 This part is available by special order, request a quote

Coil clamp for round 12 volt coils

2 required per bike. No longer available new, call us to order used coil clamps

 Sorry, this part is no longer available.

HT lead rubber, used where HT lead screws onto plug cap or pushes onto ignition coil

 This part is due back in stock soon, call 01484 841395 to reserve yours

 14717600 GU14717600 14 71 76 00
 1471 7600 1471.7600 14.71.76.00

Round 12v two pin flasher relay

See FRA17720 for rubber mount

 Order now and we will post your order within 7 days.

 17750520 GU17750520 17 75 05 20
 1775 0520 1775.0520 17.75.05.20

Kit containing two replacement 60cm silicon HT leads, lead ends and 90° plug caps. The leads are suppied as a single double length lead so you can cut it into two leads of the exact required length. Includes crimp on lead ends for standard big twin 12v round coils

Suitable for most models with coils under the tank where the HT lead is not moulded into the ignition coil. We recommend checking what type of plug cap you have and measuring your existing cable run to check this part will fit

 This part is due back in stock soon, call 01484 841395 to reserve yours

12 pin female block connector, used for main loom connections. See ELA17603 for the Molex connectors that go in this block. Use male molex connectors with this block

NB this connector has one zigzag end

 This part is due back in stock soon, call 01484 841395 to reserve yours