4 pin male block connector arranged in two rows of two used for main loom connections. See ELA17738 for the Molex connectors that go in this block. Use female molex connectors with this block

 1 in stock

Universal hydraulic brakelight switch. This hydraulic switch replaces discontinued brake light switches by bolting in place of a double banjo bolt on the handlebar or rear brake master cylinder

Especially suitable for replacing the standard switch on models where the front brakes have been 'de-linked'

 1 in stock

Combined regulator rectifier to replace separate items on Bosch equipped models. See our wiring instructions page for help installing this reg/rec.

Supplied with long leads for battery and alternator connection. Female spades for alternator and charge sensing, ring connectors for battery. NB this reg/rec should not be used with a lithium-ion battery

 1 in stock

Brand new budget starter motor and solenoid suitable as a direct replacement for Guzzi Valeo and Bosch 8 or 9 teeth starter motors. You may need to fit hex headed neutral switch bolts on some pre 1990 models to make room for the solenoid. Our part number for the bolt is SSA06016 Please note that this item may be fitted to Loop frame models with some modifications as described in Guzziology, also see https://www.thisoldtractor.com/moto_guzzi_loopframe_starter_-_how_to_replace_the_magneti_marelli_starter_with_a_valeo.html for advice on this upgrade.

Supercedes Guzzi refs. 12730705, 14730554 and 14730705

Get a discount of £20 on this item if you part exchange your existing faulty Valeo or Bosch starter motor.

 1 in stock

 30730711 GU30730711 30 73 07 11
 3073 0711 3073.0711 30.73.07.11

Universal hydraulic brake light switch. This hydraulic switch replaces discontinued brakelight switches by bolting in place of a single banjo bolt on the handlebar or rear brake master cylinder

NB stop light switch may be supplied with or without 2 pin block connector. Can be used in place of Guzzi ref. 32657060

 This part is due back in stock soon, call 01484 841395 to reserve yours

Left hand Domino type switchgear with high and low beam, pass, indicator and horn switches. Same style switch as ELA01738

On most bikes this will not plug directly into the wiring loom, you will need to match the wires to your loom. An indication of wire colours is supplied with this switchgear. Supplied with 9 pin block connector. NB does not have lights off - park - on function, you need this to be on your RH switch (e.g. ELA01729 ) or run lights always on

 This part is available by special order, request a quote

Coil clamp for round 12 volt coils

2 required per bike. No longer available new, call us to order used coil clamps

 Sorry, this part is no longer available.

HT lead rubber, used where HT lead screws onto plug cap or pushes onto ignition coil

 This part is due back in stock soon, call 01484 841395 to reserve yours

 14717600 GU14717600 14 71 76 00
 1471 7600 1471.7600 14.71.76.00

Rectifier / diode board for Bosch charging systems. High quaility replacement part sourced from Germany

See our Bosch fault finder page for help diagnosing problems on your Bosch charging system.

 This part is due back in stock soon, call 01484 841395 to reserve yours

17704300-z 17704300 GU17704300 17 70 43 00
 1770 4300 1770.4300 17.70.43.00

Brush holder for Bosch alternator stator

Also known as Guzzi ref. 17712454, 14712452

Includes brushes. See ELA17453

 This part is due back in stock soon, call 01484 841395 to reserve yours

 17712452 GU17712452 17 71 24 52
 1771 2452 1771.2452 17.71.24.52