Combined LED brake and tail light bulb (21/5W equivalent) for tail lamps. LED bulbs last longer than tungsten (up to 50000 hours), are not affected by vibration and are therefore less likely to leave you exposed on a dark night without a tail light. LED reaction time is also quicker making these a sensible upgrade to your standard bulb

This is a single white LED lamp for tail lights with a red lens. NB Not approved for road use

 3 in stock

Brakelight switch

Stop light switch also known as Guzzi ref. AP8224192
See FRA98412 for mounting screw

 2 in stock

03749845-z 03749845 GU03749845 03 74 98 45
 0374 9845 0374.9845 03.74.98.45

Set of leads for batter charging. Ring terminals for battery, 2 pin connector for charger to plug into. Often required if you charge more than one bike using your Motobatt Smart Charger

 2 in stock

Domino left hand switchgear with lights on - park - off, high and low beam, pass, indicator and horn switches. Same style switch as ELA01738.

Already wired in to 9 pin block connector (you may need to alter the wiring on your bike to correspond to this block connector). Originally fitted as standard to early V11 Sport models. See the wiring diagram on our technical documents page for help installing this switchgear. See Greg Bender's website for a custom sub-loom that enables easy fitting of this part to models previously fitted with LEGO style swithgear

 1 in stock

 01738030 GU01738030 01 73 80 30
 0173 8030 0173.8030 01.73.80.30

Right hand Domino type starter switch for use with separate throttle, e.g. Tommaselli twin pull throttles ACA10500 or ACA10501

On most bikes this will not plug directly into the wiring loom, you will need to match the wires to your loom. If replacing 'Lego' type switchgear (e.g. Le Mans 2, V50) with integrated twistgrip you will need a separate twistgrip, see ACA10500 and ACA10501. Packaging may include explanation of switchgear wire covers. This type originally fitted as standard to the early V11 Sport models. See the wiring diagram on our technical documents page for help installing this switchgear.. Molex connectors available separately.

 1 in stock

 01738800 GU01738800 01 73 88 00
 0173 8800 0173.8800 01.73.88.00

6 pin male block connector, used for main loom connections. See ELA30001 for female 6 block connector.

 1 in stock

200073020

Universal hydraulic brakelight switch. This hydraulic switch replaces discontinued brake light switches by bolting in place of a double banjo bolt on the handlebar or rear brake master cylinder

Especially suitable for replacing the standard switch on models where the front brakes have been 'de-linked'

 1 in stock

Spark plug cap

Also known as suppressor cap. Guzzi ref. 1A005382

 1 in stock

1A010839

Oil pressure sensor

Also known as Guzzi ref. 1A011730

 1 in stock

 643090 MG643090

Replacement starter motor for 2006 on models. Also known as 97729R

This is a less expensive aftermarket replacement for the OE starter.
Not interchangeable with Valeo and Bosch starters from earlier models. Get a £20 discount on this part if you send us your faulty but reconditionable starter motor

 1 in stock

 05730730 GU05730730 05 73 07 30
 0573 0730 0573.0730 05.73.07.30