Light smoke large touring screen, 230mm taller than the standard screen

230mm taller than the factory screen. Manufactured from 4mm high impact acrylic

Dimensions:
580mm overall height, approx 560mm wide

The SW-Motech EVO footrest kit offers 36 options for the rider footrest position. The kit contains rotating elements with firmly interlocking teeth which allow you to move the standard position by up to 15mm. The position of the footrest can be adjusted so that it's lower or moved forwards or backwards as well as adjusted in terms of its angle to suit your individual needs. It mounts to the original parts of the footrest holder. Improve rider comfort with this quality kit.

See this link for fitting instructions. Silver painted finish

 This part is available by special order, request a quote

This adjustable fuelling modifier uses the lambda sensor signal to the ECU. By modifying that signal it achieves an improvement in low and midrange throttle response. Comes with wiring harness and instruction manual, installation is simple and does not require any specialist tools. Suitable for all single throttle body V7, V9 and V85 TT models.

Rapid Bike EASY: A base level simple plug and play modulator equipped with a microprocessor managing the lambda sensor signal to optimize the air/fuel ratio, improve the engine efficiency and eliminate power gaps typical of the low and medium rpm range.

See installation instructions here.

Passenger saddle featuring 3D net inserts for optimal ergonomics and long travel comfort.

 This part is available by special order, request a quote

2S002031

Pair of standard KYB factory rear shocks with black springs

Low mileage OE part with preload adjustment

Sorry this part cannot be shipped to the US or Canada

6 month warranty on this part

 1 in stock

2B006790

Dimensions:
370mm x 12mm bushes

Replacement clutch plate for single plate RAM clutches

Torque setting for fitting this is 25Nm with a thread locking compound

 This part is available by special order, request a quote

HIgh performance aluminium velocity stack for airbox to throttle body union. This velocity stack replaces the standard part with an aluminium part that protrudes into the airbox. Through careful design it improves the engine response by providing an increased volume of less turbulent air to the throttle body. No modifications are required to fit this velocity stack but you should see a torque increase of around 6% at 2500 RPM and 3% increase in power at 6500 RPM

This manifold is suitable for EURO 4 and 5 models, manufactured on the shores of Lake Como. Developed for optimum power and torque on Mistral's rolling road. For best results combine with a performance air filter - SIA10434

Simple to fit, installation time is less than 30 minutes and the battery does not need to be disconnected.

Pair of factory engine crash bars finished in black essential for protecting the exposed header pipes and cylinders from expensive damage

You can mount the factory LED spotlight kit ACA02059 to these bars

Fitting kit ACA01999 also required.

2S002028

Rear hugger finished in matte black, this will protect your rear shock from road spray and grit. Mounts via three pre drilled holes and supplied brackets

Similar matte finish to front mudguard MUA00244 .
Supplied with brackets and fasteners. See here for fitting instructions. Fitment of this hugger requires some mechanical skill- if in doubt please entrust this job to a professional

Pair of sturdy black handguards, ideal for year round and mixed terrain riding. These should also save your levers from expensive damage in the unfortunate event of your bike falling over or being dropped

Compatible with the original factory handlebars on 2019 models. 2020 onward bikes may need screen adjusting forwards to allow clearance.

 This part is available by special order, request a quote