Brush kit for overhauling Bosch starter motor

The brush connections need to be soldered

 1 in stock

Ball bearing for brakelight switch

 5 in stock

 92295708 GU92295708 92 29 57 08
 9229 5708 9229.5708 92.29.57.08

Screw in brakelight switch for linked system proportioning valve or splitter

Screws into yoke mounted manifold for hand brake

 This part is available by special order, request a quote

 25657001 GU25657001 25 65 70 01
 2565 7001 2565.7001 25.65.70.01

Rubber brakelight switch cover, 90 Degree

Also known as Guzzi ref. 10352710

 1 in stock

12735100-z 12735100 GU12735100 12 73 51 00
 1273 5100 1273.5100 12.73.51.00

Self adhesive cable tie block for securing cables to bodywork and panels, particularly useful where cables must be kept out of the way under the rear mudguard. Simply stick block to bodywork, route cable tie through bracket on block and round wiring

Wiring clip. One block

 More than 5 in stock

Complete shallow bowl 190mm chrome headlight unit. Includes a pilot / parking light. A shallow bowl makes it especially suitable for mounting on Moto Guzzis underneath the instruments

Homologated for road use.

Supplied complete with H4 bulb, pilot light and four short wires (without connectors). This headlight will fit fairing cowling FAA99575 for Le Mans 1 conversions if trim strip is not fitted to inside edge of fairing. NB mounting holes will need drilling out to 10mm if fitting T3 type indicator stems

 Availability varies on this part, check availability

Condenser with mount bracket

2 required

 5 in stock

 19708620 GU19708620 19 70 86 20
 1970 8620 1970.8620 19.70.86.20

Ignition condenser for Motoplat systems, one required per bike

 Sorry, this part is no longer available.

 27710435 GU27710435 27 71 04 35
 2771 0435 2771.0435 27.71.04.35

Domino left hand switchgear with lights on - park - off, high and low beam, pass, indicator and horn switches. Same style switch as ELA01738.

Already wired in to 9 pin block connector (you may need to alter the wiring on your bike to correspond to this block connector). Originally fitted as standard to early V11 Sport models. See the wiring diagram on our technical documents page for help installing this switchgear. See Greg Bender's website for a custom sub-loom that enables easy fitting of this part to models previously fitted with LEGO style swithgear

 1 in stock

 01738030 GU01738030 01 73 80 30
 0173 8030 0173.8030 01.73.80.30

Complete electronic ignition kit containing alternator mounted ignition pickup, fittings and amplifier unit. Works with standard 12 volt coils and can be used to replace points or Bosch electronic ignition on models with Bosch charging systems. The pickups for this kit are mounted on the alternator stator. Supplied with instructions in German with wiring diagrams.

2 year warranty on Sachse ignition kits

Eliminates vague timing due to worn distributors on big twins. Preloaded with nine ignition curves, two of which are designed for twin plugged bikes. Once fitted no further adjustment should be necessary. See this link for fitting instructions. We recommend fitting Dyna coils ELA14101 with this kit. If you wish to combine this kit with uprated charging system ELA00502 you will need to make or source longer studs (M5 x 67mm x 2) for pickup, and longer centre bolt (M8 x 58mm wasted). See ACA50001 for distributor blanking plate if required

 1 in stock