Shop headings: New Spares | Used Spares | Accessories | Brands
Upper throttle cable for carb models, connects to splitter under tank. One required
We advise you to measure your existing cable before ordering in case you have a non standard set up.
1 in stock
30117560 GU30117560 30 11 75 60
3011 7560 3011.7560 30.11.75.60
£28.00
INC VAT
£23.33 EX VAT
Dellorto accelerator pump diaphragm for PHF and PHM carbs
Also known as Guzzi ref 075527555
This part is due back in stock soon, call 01484 841395 to reserve yours
14931050 GU14931050 14 93 10 50
1493 1050 1493.1050 14.93.10.50
£29.00
INC VAT
£24.17 EX VAT
Fuel level sender for fuel tank
2 pin connector block. Use seal TAA90103 with this part
This part is due back in stock soon, call 01484 841395 to reserve yours
29103050-z 29103050 GU29103050 29 10 30 50
2910 3050 2910.3050 29.10.30.50
£29.30
INC VAT
£24.42 EX VAT
Oil temperature sensor
See ELA03330 for sensor support
1 in stock
29724961 GU29724961 29 72 49 61
2972 4961 2972.4961 29.72.49.61
£30.00
INC VAT
£25.00 EX VAT
Fuel level sender for fuel tank
2 pin connector block. Use seal TAA90103 with this part
Availability varies on this part, check availability
30103060 GU30103060 30 10 30 60
3010 3060 3010.3060 30.10.30.60
£31.20
INC VAT
£26.00 EX VAT
Special Inlet rubber with HT lead guide for late Dellorto PHM carbs with a inlet stub OD of 46mm
Use clip SSA45970
This part will only fit late PHM40 carbs with 46mm inlet stubs, we recommend measuring your carbs before ordering
1 in stock
£35.00
INC VAT
£29.17 EX VAT
Manually operated fuel tap or fuel valve for models with carbs. Includes cable and remote side panel mounted knob
These new taps have a linkage that may be shorter than the original tap. In this case, you will need to swap over the linkage from your old tap and re-use it. Before using the tap you will need to release it by rotating the brass section behind the tap by quarter of a turn (anti-clockwise)
This part is due back in stock soon, call 01484 841395 to reserve yours
29105450 GU29105450 29 10 54 50
2910 5450 2910.5450 29.10.54.50
£35.00
INC VAT
£29.17 EX VAT
Manually operated fuel tap or fuel valve. Operated by turning base of tap. Supplied with nut and sealing washer
Can be used to replace electronic fuel solenoid valve 03105300 and manual fuel tap 29105460
Availability varies on this part, check availability
01105460 GU01105460 01 10 54 60
0110 5460 0110.5460 01.10.54.60
£36.00
INC VAT
£30.00 EX VAT
Plastic inlet manifold, replaces unavailable aluminium manifold. Contains inlet manifold, gasket, O rings, clip and M6 bolts to secure to head. PHF36 carb mounts direct to this manifold (no inlet manifold rubber required)
Note that on models with M8 inlet manifold bolts and standard heads (T3, 1000 SP) it will be necessary to drill out the manifold bolt holes from 6mm to 8mm to reuse your existing bolts
This part is available by special order, request a quote
£45.00
INC VAT
£37.50 EX VAT
Short alloy bellmouth / trumpet intake with domed mesh for Dellorto PHF 30 and 36 carbs, screws to rear of carb replacing air filter
2 in stock
£46.00
INC VAT
£38.33 EX VAT