Pair of handlebars used on Aprilia Mana, many customers fit these as they are more comfortable than the original handlebars. They are threaded at each end for bar ends and have holes to locate switchgear. The switchgear hole on the clutch side is threaded.

 Sorry, this part is no longer available.

 890446 MG890446

Factory heated grip kit to keep your hands toastie warm all year round. Three heat levels, integrates with the V85 TT wiring and TFT dashboard. The grips are switched on by a button on the left hand switchgear. Fully compatible with fly by wire (unlike aftermarket grips).

Includes a complete heated twistgrip, heated grip for the clutch side and fitting instructions. The thottle has to be calibrated at an official Moto Guzzi dealer with the factory software after installation.

 This part is available by special order, request a quote

2S001325

Factory heated grip kit to keep your hands toastie warm all year round.

Features 3 temperature settings

 This part is available by special order, request a quote

2S002029

Pair of adjustable Tommaselli clipons, quality aluminium castings and chrome plated tube

These clip ons pivot on the central bolt to adjust the handlebar angle, pull back angle is adjusted on the fork stanchion clamp. These clip ons are unsuitable for use with the PS12 handlebar master cylinder. Bar ends are held in by a rivet and some modification will be needed if you wish to fit bar end mirrors.

 This part is available by special order, request a quote

Pair of adjustable Tommaselli clipons, quality aluminium castings and chrome plated tube

These clip ons pivot on the central bolt to adjust the handlebar angle, pull back angle is adjusted on the fork stanchion clamp. These clip ons are unsuitable for use with the PS12 handlebar master cylinder. Bar ends are held in by a rivet and some modification will be needed if you wish to fit bar end mirrors.

 This part is available by special order, request a quote

Complete right hand Domino switchgear (starter and kill switch) plus twistgrip and pair of handlebar grips

Supplied with 4 pin Molex type connector. Use with ELA27015 to replace earlier Lego switch gear from Le Mans 2, T3 and V50 era models. No longer in production

 Sorry, this part is no longer available.

 27738815 GU27738815 27 73 88 15
 2773 8815 2773.8815 27.73.88.15

Pair of adjustable Tarozzi clipons, quality aluminium castings and chrome plated tube

38mm rise

 This part is available by special order, request a quote

Pair of adjustable Tommaselli clipons, quality aluminium castings and chrome plated tube

38mm rise, these clip ons pivot on the central bolt to adjust the handlebar angle, pull back angle is adjusted on the fork stanchion clamp. These clip ons are unsuitable for use with the PS12 handlebar master cylinder fitted to small twins unless the master cylinder is modified. Bar ends are held in by a rivet and some modification will be needed if you wish to fit bar end mirrors.

 This part is available by special order, request a quote

Pair of sturdy black handguards, ideal for year round and mixed terrain riding. These should also save your levers from expensive damage in the unfortunate event of your bike falling over or being dropped

Compatible with the original factory handlebars on 2019 models. 2020 onward bikes may need screen adjusting forwards to allow clearance.

 This part is available by special order, request a quote

Pair of adjustable Tarozzi clipons, quality aluminium castings and chrome plated tube

38mm rise

 Sorry, this part is no longer available.