Spark plug cap

Also known as suppressor cap Guzzi ref 2D000005 and GU02717450. See ELA02450 for less expensive alternative

 This part is available by special order, request a quote

2D000247

Timing sensor for ignition and tacho

3 pin block connector. Used on models with the smaller 15M ECU

 2 in stock

 01721600 GU01721600 01 72 16 00
 0172 1600 0172.1600 01.72.16.00

Ignition pickup and tacho sensor

Connector plug has two male spades. Also known as phase sensor. Used on models with the large Marelli P8 ECU. No longer available from Guzzi. Note 90° angle where cable exits sensor. See ENA90141 for O ring used to fit this part

 1 in stock

 29721660 GU29721660 29 72 16 60
 2972 1660 2972.1660 29.72.16.60

NGK Iridium DR9EIX high performance spark plug

Due to the properties of Iridium, the spark plugs centre electrode can be made with a much smaller diameter than with platinum, Gold or gold palladium and copper/nickel types without sacrificing service life. See TOA00014 for spark plug spanner

 2 in stock

Oil pressure sender, M12 thread, male bullet connector

Supercedes Guzzi no. 12768700. Some small twins also require adapter 19055800 (or ELA19720 can be fitted in place of this switch). Check which type your small twin uses before replacing.

See ENA12640 for replacement crush washer if required

 More than 5 in stock

 17768750 GU17768750 17 76 87 50
 1776 8750 1776.8750 17.76.87.50

Neutral indicator switch

 Availability varies on this part, check availability

 12207200 GU12207200 12 20 72 00
 1220 7200 1220.7200 12.20.72.00

Neutral switch

Also known as Guzzi ref. 19207200

 This part is due back in stock soon, call 01484 841395 to reserve yours

 19207220 GU19207220 19 20 72 20
 1920 7220 1920.7220 19.20.72.20

Prolong battery life with this 9 stage smart battery charger, suitable for 6v, 12v AGM and lead acid batteries.

Weatherproof - suitable for use outside 6V / 12V 1A Auto-sensing charger. Suits all AGM, Lead Acid, Calcium and Gel batteries Charges 6v and 12v batteries Ring terminal and alligator clip harnesses included Spark proof Maintains full charge Simple, connect and wait for green light Overload / Short circuit protection See ACA96001 for a spare set of charging leads (e.g. for a separate bike).

 This part is due back in stock soon, call 01484 841395 to reserve yours

Set of leads for batter charging. Ring terminals for battery, 2 pin connector for charger to plug into. Often required if you charge more than one bike using your Motobatt Smart Charger

 2 in stock

Extreme performance hybrid maintenance free Motobatt 12 volt battery. MFLEX technology means you have adjustable terminal options and maximum flexibility when installing.

We have sourced this battery especially for high compression big twins which need enhanced cranking amps for starting. Suitable for special builds with non standard battery locations (e.g. under the gearbox). This hybrid battery offers 330 cranking amps for reliable and hassle free starting. This is at least 100% more cranking amps than comparable lead acid or AGM batteries Superior conductivity from pure copper terminals.

Compared to traditional lead acid batteries a hybrid battery is

• 90% STRONGER in cranking power .
• 30% LIGHTER in weight.
• 500% LONGER, in life cycle.
• 50% LOWER in self-discharge rate
• FASTER in charging time.
• CONSTANT CRANKING, in cold weather.
• PROTECTION, against over-charging over-discharging and heat

• COMPATIBLE, with all OEM charging system.
• 200% MORE AH, in Capacity.
• TEMPERATURE STABLE, in all weather conditions.
• LONGER LIFE CYCLE.
• STRONGER CRANKING, in cold weather.
• ADAPTABLE, to lead acid charger.
• MORE CONNECTIONS, extra electronics connections

 Order now and we will post your order within 7 days.

 638733 MG638733