Stainless steel exhaust stud kit consisting of 4 x studs, 4 x dome head nuts, 4 x wavy washers and 4 x flat washers
On pre-1998 models we recommend combining with a pair of new exhaust polished aluminium flanges - EXA30032
More than 5 in stock
96508040 GU96508040 96 50 80 40
9650 8040 9650.8040 96.50.80.40
£21.00
INC VAT
£17.50 EX VAT
M16 stainless steel full nut and thick washer for rear wheel spindle
Also referred to as Guzzi ref. 14634400 and 92602316
More than 5 in stock
92602316-z 92602316 GU92602316 92 60 23 16
9260 2316 9260.2316 92.60.23.16
£10.50
INC VAT
£8.75 EX VAT
Output oil seal for drive box
This oil seal fits output side of bevel box
More than 5 in stock
90407085-z 90407085 GU90407085 90 40 70 85
9040 7085 9040.7085 90.40.70.85
£14.00
INC VAT
£11.67 EX VAT
Full engine and gearbox seal kit, includes all necessary seals for a complete engine and gearbox overhaul.
Full gasket sets also available. Can also be fitted to models equipped with a Saprisa charging system if front crank oil seal ENA94238 is ordered
More than 5 in stock
17999550 GU17999550 17 99 95 50
1799 9550 1799.9550 17.99.95.50
£75.00
INC VAT
£62.50 EX VAT
Front oil seal for cam shaft
More than 5 in stock
90401530-z 90401530 GU90401530 90 40 15 30
9040 1530 9040.1530 90.40.15.30
£9.50
INC VAT
£7.92 EX VAT
Final drive inner output seal
For Breva 750 from frame no. LL111908
2 in stock
90407591-z 90407591 GU90407591 90 40 75 91
9040 7591 9040.7591 90.40.75.91
£15.80
INC VAT
£13.17 EX VAT
Round 12v two pin flasher relay
See FRA17720 for rubber mount
More than 5 in stock
17750520 GU17750520 17 75 05 20
1775 0520 1775.0520 17.75.05.20
£7.60
INC VAT
£6.33 EX VAT
Air filter, flat paper cartridge type
See SIA10425 for a reusable performance air filter
More than 5 in stock
AP8104242
£12.00
INC VAT
£10.00 EX VAT
Clutch cable with adjuster for gearbox end
Suitable for all T3 and T4 models fitted with high bars
2 in stock
29093000-z 29093000 GU29093000 29 09 30 00
2909 3000 2909.3000 29.09.30.00
£21.00
INC VAT
£17.50 EX VAT
The BoosterPlug is an effective and cost efficient way to cure the fuelling problems common to all modern fuel injected Guzzi's.
Plugging directly into the wiring harness using original connectors, with no cutting or splicing required, installation takes less than ten minutes.
The BoosterPlug features a unique technology to provide your bike with a controlled fuel enrichment in all ambient temperature situations. No other Plug and Play device does this. A richer mixture is provided only when needed i.e at low RPMs and when accelerating. On open roads at a constant speed the Boosterplug sits idle to keep fuel consumption low.
Make your bike run as it should have done from the factory!
This part is due back in stock soon, call 01484 841395 to reserve yours
£129.00
INC VAT
£107.50 EX VAT