Pair of engine crash bars finished in tough black. The heads and rocker covers are vulnerable on these bikes and can be badly damaged by even a minor accident, replacement cost can be more than £1000 so protect your bike with these bars.

Supplied with fitting hardware and bracket finished in black, this crashbar has been specially developed for the second generation V7. See our technical documents section for installation instructions. Engine bars - essential protection for your bike.

 1 in stock

Replacement starter motor for 2006 on models. Also known as 97729R

This is a less expensive aftermarket replacement for the OE starter.
Not interchangeable with Valeo and Bosch starters from earlier models. Get a £20 discount on this part if you send us your faulty but reconditionable starter motor

 1 in stock

 05730730 GU05730730 05 73 07 30
 0573 0730 0573.0730 05.73.07.30

HIgh performance aluminium velocity stack for airbox to throttle body union. This velocity stack replaces the standard part with an aluminium part that protrudes into the airbox. Through careful design it improves the engine response by providing an increased volume of less turbulent air to the throttle body. No modifications are required to fit this velocity stack but you should see a torque increase of around 6% at 2500 RPM and 3% increase in power at 6500 RPM

This manifold is suitable for EURO 4 and 5 models, manufactured on the shores of Lake Como. Developed for optimum power and torque on Mistral's rolling road. For best results combine with a performance air filter - SIA10434

Simple to fit, installation time is less than 30 minutes and the battery does not need to be disconnected.

 This part is available by special order, request a quote

This adjustable fuelling modifier uses the lambda sensor signal to the ECU. By modifying that signal it achieves an improvement in low and midrange throttle response. Comes with wiring harness and instruction manual, installation is simple and does not require any specialist tools. Suitable for all single throttle body V7, V9 and V85 TT models.

Rapid Bike EASY: A base level simple plug and play modulator equipped with a microprocessor managing the lambda sensor signal to optimize the air/fuel ratio, improve the engine efficiency and eliminate power gaps typical of the low and medium rpm range.

See installation instructions here.

 Order now and we will post your order within 7 days.

Clutch friction plate

 This part is available by special order, request a quote

2A000969

HIgh performance aluminium velocity stack for airbox to throttle body union on single throttle body models. This velocity stack replaces the standard part with an aluminium part that protrudes into the airbox. Through careful design it improves the engine response by providing an increased volume of less turbulent air to the throttle body. No modifications are required to fit this velocity stack but you should see a torque increase of around 6% at 2500 RPM and 3% increase in power at 6500 RPM

This manifold is suitable for EURO 4 and 5 models, manufactured on the shores of Lake Como. Developed for optimum power and torque on Mistral's rolling road. For best results combine with a performance air filter - SIA10434

Simple to fit, installation time is less than 30 minutes and the battery does not need to be disconnected.

 This part is due back in stock soon, call 01484 841395 to reserve yours

Clutch friction plate

 This part is available by special order, request a quote

2A000770

Rear brake master cylinder, foot operated. Brembo no longer offer overhaul kits for recent models so this is your only option if your master cylinder is faulty.

 This part is available by special order, request a quote

2B000508

Bridgestone Battlax 110/90-18 speed rated to 130 MPH.

Bridgestone's Battlax BT46 replaces the iconic Battlax BT-45. The iconic BT-45 was upgraded with a new modern design that increases wet performance with no impact on its well-known dry handling performance and high mileage. RC Polymer technology optimizes the distribution of silica in the rubber compound and improves tread flexibility, allowing greater contact with the road surface in both hot and cold conditions. The reduction in molecular friction also improves rolling resistance, therefore increasing fuel economy.

 Order now and we will post your order within 7 days.

BT46

Pair of sturdy black ABS handguards with fitting hardware, these protect clutch and brake levers from damage as well as providing some weather protection for your hands. Supplied as a pair, a great accessory for UK riding conditions

Single point mounting for easy installation, bar end weights are retained.

 This part is available by special order, request a quote