Page 3 of 3
Brembo Handlebar Master Cylinder PS13 CLA03145 Fits V7 Sport, S3, 750S, 850/1000 ALL Models, Cali 1100, Cali EV, Cali Stone, Cali Jackal, 1100 Sport ALL, Daytona, Centauro Brembo PS 13 handlebar mounted clutch master cylinder, supplied complete with lever. This part is available by special order, request a quote £175.00 INC VAT £145.83 EX VAT Clutch Kit Updated Splined Centre CLA20302 Fits 850 GT, V7 Sport, S3, 750S, 850/1000 ALL Models, 1100 Sport ALL, Cali 1100 (1994-1997), Cali EV, Quota 1100, Centauro, Daytona Clutch plate kit consisting of 2 x friction plates, 1 x intermediate plate, deep splined clutch centre / boss and tabbed lock washer (not shown). For models with the early type shallow spline plates this is a worthwhile upgrade kit to the better deep splined centre and plates. Clutch plate alignment tool also available, see TOA30510. Suitable for all 5 speed dual plate clutch models Save £20 on the cost of these components if bought seperately. Does not include clutch springs (see CLA13100). Thicker side of each friction plate should face transmission This part is due back in stock soon, call 01484 841395 to reserve yours £186.50 INC VAT £155.42 EX VAT RAM Clutch Kit Upgrade CLA20305 Fits 850 GT, V7 Sport, S3, 750S, 850/1000 ALL Models Complete single disc clutch kit for 5 speed big twins containing flywheel, new deep spline clutch hub, friction plate, spring plate, pressure plate, and flywheel bolts. Suitable for all big twins with either distributor or crankshaft mounted ignition system, not suitable for Digiplex equipped models. This clutch upgrade has the following advanges over the old two plate clutch:
- Reduction in flywheel and clutch weight of approx. 1KG
- Improved acceleration
- Smoother gear changes at high RPM
- Quicker engine decelleration
- Reduction in engine vibration as the clutch assembly is (this is not possible with the original clutch)
- Lighter handlebar clutch lever action
- More precise clutch engagement and disengagement.
- More progressive clutch engagement.
- Increased ability to handle higher torque and horsepower.
- Lower clutch disk wear (reduced maintenance)
- Fewer parts (no intermediate plate, no second friction plate) to wear out
- Ease of assembly - gearbox can be fitted to engine without centering of the clutch disk.
Kits are complete as shown including: flywheel, new deep spline clutch hub, friction plate, spring plate, pressure plate, and flywheel bolts. See CLA30399 for replacement clutch plate. See the expoded diagram on our technical documents page for more information about this part.
Please note you will need 6 M8 Schnorr washers ENA14901 which are not included in the kit. See ENA37705 for replacement flywheel bolts This part is due back in stock soon, call 01484 841395 to reserve yours £520.00 INC VAT £433.33 EX VAT Page 3 of 3
|