Round 12v two pin flasher relay

See FRA17720 for rubber mount

 Order now and we will post your order within 7 days.

 17750520 GU17750520 17 75 05 20
 1775 0520 1775.0520 17.75.05.20

Kit containing two replacement 60cm silicon HT leads, lead ends and 90° plug caps. The leads are suppied as a single double length lead so you can cut it into two leads of the exact required length. Includes crimp on lead ends for standard big twin 12v round coils

Suitable for most models with coils under the tank where the HT lead is not moulded into the ignition coil. We recommend checking what type of plug cap you have and measuring your existing cable run to check this part will fit

 This part is due back in stock soon, call 01484 841395 to reserve yours

Marelli phase sensor for Digiplex ignition and tacho

2 pin block connector

 This part is available by special order, request a quote

 20721610 GU20721610 20 72 16 10
 2072 1610 2072.1610 20.72.16.10

Motoplat ignition unit for one cylinder (2 required per bike)

Also known as Guzzi ref. 23721493, 27721435, 23721491, 23721490, 27721435

 This part is available by special order, request a quote

 23721494 GU23721494 23 72 14 94
 2372 1494 2372.1494 23.72.14.94

Replacement regulator rectifier for models fitted with the Ducati charging system. This is a quality unit and is supplied with fitting instructions

Connections: 2 x yellow male bullet, 1 x white female bullet, 1 x black ring, 1 x red ring. You will need to reuse your existing block connectors to connect this to your loom. See this wiring diagram for wiring connections

 This part is due back in stock soon, call 01484 841395 to reserve yours

37703805-z 37703805 GU37703805 37 70 38 05
 3770 3805 3770.3805 37.70.38.05

Ducati regulator rectifier for models fitted with the Ducati charging system

Connections: 2 x yellow male bullet, 1 x white female bullet, 1 x black male bullet, 1 x red male bullet. See ELA28739 for a less expensive alternative

 This part is due back in stock soon, call 01484 841395 to reserve yours

37703805-z 37703805 GU37703805 37 70 38 05
 3770 3805 3770.3805 37.70.38.05

Regulator rectifier for Saprisa charging systems

Male spade connectors on regulator, may be supplied with 7 connectors - see the diagram on our technical documents page for help installing this part. The standard black block connector is not compatible with the updated 7 pin reg/rec, you will instead need to fit female spade connectors to your wires.

 This part is due back in stock soon, call 01484 841395 to reserve yours

28703800-z 28703800 GU28703800 28 70 38 00
 2870 3800 2870.3800 28.70.38.00

Phase sensor for Motoplat ignition

Connector contains two female bullet type connectors. Also known as Guzzi ref. 27722235 ignition pickup plate

 This part is due back in stock soon, call 01484 841395 to reserve yours

 29722270 GU29722270 29 72 22 70
 2972 2270 2972.2270 29.72.22.70

12 volt coil used on late Guzzis

Sometimes referred to as the 'square coil', two required per bike. See ELA00001 for crimp on HT lead connector

 This part is due back in stock soon, call 01484 841395 to reserve yours

 30716500 GU30716500 30 71 65 00
 3071 6500 3071.6500 30.71.65.00

Brakelight switch for handlebar mounted master cylinder

Stop light switch also known as Guzzi ref. 30530526. Please compare with your existing switch to check compatibility. Can be used as a substitute for ELA27815. See ELA30861 for less expensive alternative part. Sometimes supplied with three terminals, in this instance disregard middle terminal

 This part is due back in stock soon, call 01484 841395 to reserve yours

 30749860 GU30749860 30 74 98 60
 3074 9860 3074.9860 30.74.98.60