Combined LED brake and tail light bulb (21/5W equivalent) for tail lamps. LED bulbs last longer than tungsten (up to 50000 hours), are not affected by vibration and are therefore less likely to leave you exposed on a dark night without a tail light. LED reaction time is also quicker making these a sensible upgrade to your standard bulb

This is a single white LED lamp for tail lights with a red lens. NB Not approved for road use

 3 in stock

HT lead rubber, used where HT lead screws onto plug cap or pushes onto ignition coil

 2 in stock

 14717600 GU14717600 14 71 76 00
 1471 7600 1471.7600 14.71.76.00

Weatherproof in-line fuseholder, accepts a standard blade fuse (see ELA00115 or ELA00130)

Ideal for wiring auxiliary equipment like Satnavs, additional lights or fixing the CARC model starting problem with a direct supply from the battery

 3 in stock

3 position 4 pin ignition switch includes start position

Male spade connectors to rear, supplied with 2 keys

 This part is available by special order, request a quote

 12735300 GU12735300 12 73 53 00
 1273 5300 1273.5300 12.73.53.00

Set of Facet points

 This part is due back in stock soon, call 01484 841395 to reserve yours

 12715445 GU12715445 12 71 54 45
 1271 5445 1271.5445 12.71.54.45

Silca key blank for Zadi ignition keys - match profile to your existing key

 3 in stock

ZD9

Silca key blank for ignition key, match profile to your existing key

 This part is due back in stock soon, call 01484 841395 to reserve yours

NE5

Silca key blank for ignition key, match profile to your existing key

 This part is due back in stock soon, call 01484 841395 to reserve yours

12 volt single output 3 Ohm ignition coil (lead to distributor)

Push fit HT lead, see ELA00001 for crimp on HT lead connector. Supplied without coil clamp

 This part is due back in stock soon, call 01484 841395 to reserve yours

 26716504 GU26716504 26 71 65 04
 2671 6504 2671.6504 26.71.65.04

Kit containing two replacement 60cm silicon HT leads, lead ends and 90° plug caps. The leads are suppied as a single double length lead so you can cut it into two leads of the exact required length. Includes crimp on lead ends for standard big twin 12v round coils

Suitable for most models with coils under the tank where the HT lead is not moulded into the ignition coil. We recommend checking what type of plug cap you have and measuring your existing cable run to check this part will fit

 This part is due back in stock soon, call 01484 841395 to reserve yours