High quality rear sets beautifully fabricated in black billet aluminium. These move the foot position back by 12cm and up by 3.5cm for a racier stance

All fittings included. Please note that on the Stone and Special versions you will either need to replace the original silencers or remove the heat shield.

 Availability varies on this part, check availability

Black M6 x 16mm pozi drive pan head screw used for fixing fairings and screens

Use with washer FAA95204

 2 in stock

Black M6 x 16mm button head screw used for fixing fairings and screens

Can be used in place of AP8150377

 More than 5 in stock

Self adhesive cable tie block for securing cables to bodywork and panels, particularly useful where cables must be kept out of the way under the rear mudguard. Simply stick block to bodywork, route cable tie through bracket on block and round wiring

Wiring clip. One block

 More than 5 in stock

Centre stand kit finished in black

Supplied with brackets and fitting hardware. See this link for installation instructions.

 This part is available by special order, request a quote

Centre stand kit finished in black

Supplied with brackets and fitting hardware. See this link for installation instructions.

 This part is available by special order, request a quote

Retaining circlip for footpeg retaining pin

 2 in stock

AP8120573

Pair of engine crash bars finished in tough black. The heads and rocker covers are vulnerable on these bikes and can be badly damaged by even a minor accident, replacement cost can be more than £1000 so protect your bike with these bars.

Supplied with fitting hardware and bracket finished in black, this crashbar has been specially developed for the second generation V7. See our technical documents section for installation instructions. Engine bars - essential protection for your bike.

 This part is available by special order, request a quote

Pair of engine crash bars finished in bright Italian chrome. The heads and rocker covers are vulnerable on these bikes and can be badly damaged by even a minor accident, replacement cost can be more than £1000 so protect your bike with these bars.

Supplied with fitting hardware and black bracket, this crashbar has been specially developed for the second generation V7. See our technical documents section for installation instructions. Engine bars - essential protection for your bike.

 1 in stock

Pair of Hepco and Becker engine crash bars finished in black. The heads and rocker covers are vulnerable on these bikes and can be badly damaged by even a minor accident, replacement cost can be more than £1000 so protect your bike with these bars.

Supplied with fitting hardware and instructions. See this link for installation instructions

 This part is available by special order, request a quote