Oil pressure sender, M12 thread, male bullet connector

Supercedes Guzzi no. 12768700. Some small twins also require adapter 19055800 (or ELA19720 can be fitted in place of this switch). Check which type your small twin uses before replacing.

See ENA12640 for replacement crush washer if required

 More than 5 in stock

 17768750 GU17768750 17 76 87 50
 1776 8750 1776.8750 17.76.87.50

Cable splitter box for models with a single cable from the choke or throttle, high quality replacement item from Domino

 4 in stock

 30607910 GU30607910 30 60 79 10
 3060 7910 3060.7910 30.60.79.10

Domino left hand switchgear with lights on - park - off, high and low beam, pass, indicator and horn switches. Same style switch as ELA01738.

Already wired in to 9 pin block connector (you may need to alter the wiring on your bike to correspond to this block connector). Originally fitted as standard to early V11 Sport models. See the wiring diagram on our technical documents page for help installing this switchgear. See Greg Bender's website for a custom sub-loom that enables easy fitting of this part to models previously fitted with LEGO style swithgear

 1 in stock

 01738030 GU01738030 01 73 80 30
 0173 8030 0173.8030 01.73.80.30

Set of ignition points (made up of two boxes of contacts)

 More than 5 in stock

 19709620 GU19709620 19 70 96 20
 1970 9620 1970.9620 19.70.96.20

TPS for throttle body

On Cali 1100 check which TPS you have (varies according to ECU)

 2 in stock

 01530500 GU01530500 01 53 05 00
 0153 0500 0153.0500 01.53.05.00

Single metal fuel banjo for Dellorto carbs. Fuel filter FUA60888 sits inside this part and makes seal to carb

Also known as Guzzi ref. 10934600 and Ducati ref. 075527250

 More than 5 in stock

 13934600 GU13934600 13 93 46 00
 1393 4600 1393.4600 13.93.46.00

Also fits Ducati 350-500 Twin, Ducati 350-500 Twin GTV, Ducati 350-500 Twin Sport, Ducati 500 SL Pantah, Ducati 600 SL Pantah, Ducati 750/900 SS Koewe, Ducati 860/900 GTS, Ducati 900 Darmah, Ducati 900 MHR, S2, Ducati 900 MHR-I, Ducati 1000 MHR-2,S2

Kit of 8 frame and footpeg caps to finish off your V100. The kit, made of plastic material resistant to UV rays and heat, was developed specifically for the Moto Guzzi V100. It consists of 6 footrest caps and 2 frame caps, covering both the right and left sides. The frame caps are finished with a Moto Guzzi eagle emblem in keeping with the branding elsewhere on the V100. These frame caps tidy the side profile of your machine and prevent water and road spray getting into the frame.

Note that the included M10 washer is required to space the gear lever so it is clear of the installed plugs. Scan the QR code on the box for a short video guide to installation.

 2 in stock

DNA high performance air filter

Optimise air flow with this high quality reusable DNA air filter which has been proven on Mistral's dyno to increase power and torque, especially when combined with a Mistral silencer.

 1 in stock

2B009776

The Mistral V-Twin boost is an effective and cost efficient way to cure the fuelling problems common to all modern fuel injected Guzzi's. The V85 TT runs particularly lean and will benefit more than most bikes from the installation of a V-Twin Boost.
Plugging directly into the wiring harness using original connectors, with no cutting or splicing required, installation takes less than ten minutes.

The V-Twin boost features a unique technology to provide your bike with a controlled fuel enrichment.
Make your bike run as it should have done from the factory!

• Quick and easy installation
• Resistant to atmospheric agents and vibrations
• Optimized by Mistral for your bike
• Best response to the opening of the throttle
• Better torque at low-medium range
• Reduction of the on/off effect
• Correct air/fuel ratio in all conditions with real-time modification

 1 in stock

"The Carburettor Manual" is a comprehensive guide from Dellorto to the setting up and use of tapered needle motorcycle carburettors. Covers principle of operation of all Dellorto tapered needle carburettors 1970 onwards. 33 pages with colour pictures and diagrams. Also included is the original Dellorto "Tuning Guide 1.1" for carburettors, which gives advice on the choice, setting and use of a Dellorto tapered needle carburettor which includes colour carburettor cross sections showing the multiple stages of carburettor operation. Also contains float height and tapered needle selection tables.

 5 in stock