Stainless steel braided hose oil lines for heads on square barrel models. See ENA14662 if you also need threaded link to cylinder head
Always replace crush washers (SIA12200 x 2 and SIA10900 x 2) when replacing oil lines, you may also require our banjo bolt ENA95990. Also known as Guzzi ref. 01153600 and 01153602
5 in stock
14153660 GU14153660 14 15 36 60
1415 3660 1415.3660 14.15.36.60
£53.00
INC VAT
£44.17 EX VAT
Sebac fork damper, standard damping rate
Also known as Guzzi ref. 18526460. See OIA01001 for ATF (used in place of fork oil)
4 in stock
14526455-z 14526455 GU14526455 14 52 64 55
1452 6455 1452.6455 14.52.64.55
Also fits Benelli Sei 900
£27.90
INC VAT
£23.25 EX VAT
Sebac fork damper, standard damping rate
See OIA01001 for ATF (used in place of fork oil)
4 in stock
14526407-z 14526407 GU14526407 14 52 64 07
1452 6407 1452.6407 14.52.64.07
£32.00
INC VAT
£26.67 EX VAT
Fuel pipe assembly including 'x' crossover piece
See FUA00004 for pipe clips. Can also be used in place of Guzzi ref. 12106501 on Loop frame models if cut to length
More than 5 in stock
29106500-z 29106500 GU29106500 29 10 65 00
2910 6500 2910.6500 29.10.65.00
Also fits Guzzi V7 Special, V7 700
£20.00
INC VAT
£16.67 EX VAT
Nut for clutch centre gear CLA30810, fits on gearbox input shaft
See TOA14903 for special tool
3 in stock
93601022-z 93601022 GU93601022 93 60 10 22
9360 1022 9360.1022 93.60.10.22
£10.00
INC VAT
£8.33 EX VAT
Complete (rev counter) tacho cable
We advise you to measure your existing cable before ordering in case you have a non standard set up.
More than 5 in stock
19768100-z 19768100 GU19768100 19 76 81 00
1976 8100 1976.8100 19.76.81.00
£12.50
INC VAT
£10.42 EX VAT
This adjustable fuelling modifier uses the lambda sensor signal to the ECU. By modifying that signal it achieves an improvement in low and midrange throttle response. Comes with wiring harness and instruction manual, installation is simple and does not require any specialist tools. Suitable for all single throttle body V7, V9 and V85 TT models.
Rapid Bike EASY: A base level simple plug and play modulator equipped with a microprocessor managing the lambda sensor signal to optimize the air/fuel ratio, improve the engine efficiency and eliminate power gaps typical of the low and medium rpm range.
See installation instructions here.
1 in stock
£149.00
INC VAT
£124.17 EX VAT
This handlebar riser kit moves the handlebars up by 35mm resulting in much improved comfort. Finished in black, this is a high quality Italian engineered kit. For yokes with 32-35mm clamp bolt centres
Kit contains fitting instructions, zinc finish bolts, bolt head plugs and risers. Normally this kit can be fitted without modifying your brakelines or control cables.
Improve riding comfort with this riser kit
1 in stock
£45.00
INC VAT
£37.50 EX VAT
Replacement starter motor for 2006 on models. Also known as 97729R
This is a less expensive aftermarket replacement for the OE starter.
Not interchangeable with Valeo and Bosch starters from earlier models. Get a £20 discount on this part if you send us your faulty but reconditionable starter motor
1 in stock
05730730 GU05730730 05 73 07 30
0573 0730 0573.0730 05.73.07.30
£150.00
INC VAT
£125.00 EX VAT
Brand new genuine Valeo starter motor and solenoid suitable as a direct replacement for Guzzi Valeo and Bosch 8 or 9 teeth starter motors. You may need to fit hex headed neutral switch bolts on some pre 1990 models to make room for the solenoid. Our part number for the bolt is SSA06016
Please note that this item may be fitted to Loop frame models with some modifications as described in Guzziology, also see https://www.thisoldtractor.com/moto_guzzi_loopframe_starter_-_how_to_replace_the_magneti_marelli_starter_with_a_valeo.html for advice on this upgrade.
This is a genuine Valeo starter made in the EU- please do not confuse with the cheap Chinese copies that sometimes appear on eBay.
Supercedes Guzzi refs. 12730705, 14730554 and 14730705
Please note you can get a discount of £30 on this item if you part exchange your existing faulty starter motor. See ELA30837 for less expensive alternative part
1 in stock
30730711 GU30730711 30 73 07 11
3073 0711 3073.0711 30.73.07.11
£231.00
INC VAT
£192.50 EX VAT