Brembo caliper cover for models with obsolete twin bleed calipers
P9 caliper cover includes cutout each side for bleed nipple. Also known as Guzzi ref. 14654700, 17654760. Please note you may need to trim away the four moulded lugs at the bottom of the cover otherwise these may clash with your pad pins
More than 5 in stock
20325410 GU20325410 20 32 54 10
2032 5410 2032.5410 20.32.54.10
£11.00
INC VAT
£9.17 EX VAT
Large dust cover for your bike when parked up in your garage. Prevents dust and dirt settling on your pride and joy. Also useful for hiding your bike from prying eyes when your garage door is open. Also see tank protector SIA00001 for extra protection.
Breathable, tear resistant fabric.
1 in stock
£19.00
INC VAT
£15.83 EX VAT
Thick protective tank cover for your workshop. Ideal for preventing expensive damage to your motorcycle tank when working on your bike (avoid brake fluid spills etc...) and also useful for leaving on your bike when not in use to avoid accidental scratches. Special anti-slip material on underside secures cover to your motorcycle tank when in use. Upper side is nylon for ease of cleaning.
1 in stock
£18.00
INC VAT
£15.00 EX VAT
Black spark plug cap, this does not include the 90 degree bend or HT lead but is significantly cheaper than the genuine part
For models with 4 valves per cylinder, with the very easily damaged internal plug caps.
Also known as suppressor cap.
NOT for models with 2 valves per cylinder.
See ELA18134 for HT leads, although these come with different plug caps.
2 in stock
883028 MG883028
£10.00
INC VAT
£8.33 EX VAT
Pair of organic EBC FA256 rear brake pads
Twin pin fitting. Pre 2012 V7 models use a different brake pad with only one pad pin hole. Also known as Guzzi ref 2R000248
3 in stock
AP8133798
£19.30
INC VAT
£16.08 EX VAT
Dimensions:
M10 conventional thread, approx. 240mm reach to far edge of mirror, mirror 110mm diameter
Black handlebar mounted mirror. Conventional M10 thread, head is threaded for left or right hand fitment.
Supercedes BUMM mirror HAA36021W. See ACA00101 for a black mirror extender kit to extend the reach of this mirror.
2 in stock
£18.00
INC VAT
£15.00 EX VAT
Single 100cm length of neoprene rubber pipe used for oil breather applications depending on model. Can be used as fuel pipe on carb bikes. Also see FUA00011 as alternative for this pipe
Use hose clip FUA00004
More than 5 in stock
£7.00
INC VAT
£5.83 EX VAT
12 volt relay for fuel injection system
4 pin relay, also known as Guzzi ref. 895481
2 in stock
AP8124869
Also fits Aprilia 1000 RSV4 R APRC , BJ 2013 - 2014, Aprilia 1000 RSV4 RF , BJ 2017 -, Aprilia 1000 RSV4 RR , BJ 2015 - 2015, Aprilia 1000 RSV4 RR , BJ 2016 - 2016, Aprilia 1000 RSV4 RR , BJ 2017 -, Aprilia 1100 Tuono V4 Factory , BJ 2015 -, Aprilia 1100 Tuono V4 RF , BJ 2017 - 2019, Aprilia 1100 Tuono V4 RR , BJ 2016 - 2017, Aprilia 1100 V4 Tuono Factory , BJ 2017 -, Aprilia 1200 Caponord Rally , BJ 2015 - 2017, Aprilia 1200 Caponord Travel Pack , BJ 2013 - 2016, Aprilia 750 Shiver , BJ 2014 - 2017, Aprilia 900 Dorsoduro , BJ 2017 -, Aprilia 900 Shiver , BJ 2017 -
£15.60
INC VAT
£13.00 EX VAT
Choke cable for remote left cylinder mounted choke, fits both carbs
Alternative for Le Mans models that were fitted with the shorter version of the choke cable. We advise you to measure your existing cable before ordering in case you have a non standard set up. See CAA28133 for long version.
1 in stock
28133500-Z
£7.50
INC VAT
£6.25 EX VAT
Clutch cable with adjuster for gearbox end
Suitable for all T3 and T4 models fitted with high bars
2 in stock
29093000-z 29093000 GU29093000 29 09 30 00
2909 3000 2909.3000 29.09.30.00
£21.00
INC VAT
£17.50 EX VAT