Complete 12v 300w alternator for Saprisa charging systems

No longer in production

 Sorry, this part is no longer available.

 28712400 GU28712400 28 71 24 00
 2871 2400 2871.2400 28.71.24.00

Marelli air temperature sensor

Supplied with screws. Superceded by ELA30330

 Sorry, this part is no longer available.

 30729331 GU30729331 30 72 93 31
 3072 9331 3072.9331 30.72.93.31

Fuel level sender for fuel tank

 Sorry, this part is no longer available.

01103030

Alternator stator for Bosch charging systems, this does not include the plate and brush holders

To fit this you will need to solder in the three wires from the windings. Replacement rotors and brushes also available. See ELA00503 for a complete higher output upgrade for your charging system

 This part is available by special order, request a quote

 17712400 GU17712400 17 71 24 00
 1771 2400 1771.2400 17.71.24.00

12 volt single output 3 Ohm ignition coil (lead to distributor)

Push fit HT lead, see ELA00001 for crimp on HT lead connector. Supplied without coil clamp

 This part is due back in stock soon, call 01484 841395 to reserve yours

 26716504 GU26716504 26 71 65 04
 2671 6504 2671.6504 26.71.65.04

Condenser with cable and mount bracket

See SIA12785 for a long life replacement

 This part is due back in stock soon, call 01484 841395 to reserve yours

 12715421 GU12715421 12 71 54 21
 1271 5421 1271.5421 12.71.54.21

Fuel level sender for fuel tank

2 pin connector block

 This part is available by special order, request a quote

 30103000 GU30103000 30 10 30 00
 3010 3000 3010.3000 30.10.30.00

Speedo sensor with 100cm lead and 3 pin plug for non ABS equipped models

 This part is available by special order, request a quote

AP8124985

Prolong battery life with this 9 stage smart battery charger, suitable for 6v, 12v AGM and lead acid batteries.

Weatherproof - suitable for use outside 6V / 12V 1A Auto-sensing charger. Suits all AGM, Lead Acid, Calcium and Gel batteries Charges 6v and 12v batteries Ring terminal and alligator clip harnesses included Spark proof Maintains full charge Simple, connect and wait for green light Overload / Short circuit protection See ACA96001 for a spare set of charging leads (e.g. for a separate bike).

 This part is due back in stock soon, call 01484 841395 to reserve yours

Complete electronic ignition kit containing distributor mounted ignition pickup, fittings and amplifier unit. Requires a pair of 12v coils ELA14500
Tacho will not work with this kit unless a amplifier is bought (enquire for details)
2 year warranty on Sachse ignition kits

Once fitted no further adjustment should be necessary. See this link for fitting instructions.

 This part is available by special order, request a quote