Brand new budget starter motor and solenoid suitable as a direct replacement for Guzzi Valeo and Bosch 8 or 9 teeth starter motors. You may need to fit hex headed neutral switch bolts on some pre 1990 models to make room for the solenoid. Our part number for the bolt is SSA06016 Please note that this item may be fitted to Loop frame models with some modifications as described in Guzziology, also see https://www.thisoldtractor.com/moto_guzzi_loopframe_starter_-_how_to_replace_the_magneti_marelli_starter_with_a_valeo.html for advice on this upgrade.
Supercedes Guzzi refs. 12730705, 14730554 and 14730705
Get a discount of £20 on this item if you part exchange your existing faulty Valeo or Bosch starter motor.
1 in stock
30730711 GU30730711 30 73 07 11
3073 0711 3073.0711 30.73.07.11
£125.00
INC VAT
£104.17 EX VAT
Short alloy bellmouth / trumpet intake with domed mesh for Dellorto PHF 30 and 36 carbs, screws to rear of carb replacing air filter
2 in stock
£46.00
INC VAT
£38.33 EX VAT
Dellorto choke jet size 70
2 in stock
14936050 GU14936050 14 93 60 50
1493 6050 1493.6050 14.93.60.50
£7.75
INC VAT
£6.46 EX VAT
Carb gasket kit / rebuild kit for Dellorto VHB29, VHB30, VHB24 and VHB26 carbs
Carb overhaul kit, fuel filter FUA60888 and float bowl seal FUA90001 available separately to this seal kit. As this kit is intended for several different carbs you may have gaskets or O rings remaining after rebuilding. More information on rebuilding your VHB carb can be found here.
More than 5 in stock
17939950 GU17939950 17 93 99 50
1793 9950 1793.9950 17.93.99.50
£12.50
INC VAT
£10.42 EX VAT
Dellorto carb gasket kit / rebuild kit for PHF30, contains necessary rubber seals and gaskets to recondition a carburettor
Carb overhaul kit, fuel filter FUA60888 and float bowl seal FUA90001 available separately to this seal kit
2 in stock
28939911 GU28939911 28 93 99 11
2893 9911 2893.9911 28.93.99.11
£21.00
INC VAT
£17.50 EX VAT
Pair of universal Domino chromed handlebars, medium rise.
Not suitable for V65 GT, Mille GT or other models with wide handlebar clamps - see dimensions if in doubt about suitability for your bike
1 in stock
£48.00
INC VAT
£40.00 EX VAT
UFI 30 814 00 flat type air filter, paper filament in rubber surround
NB Packaging may vary
More than 5 in stock
28113650 GU28113650 28 11 36 50
2811 3650 2811.3650 28.11.36.50
£8.00
INC VAT
£6.67 EX VAT
UFI 25 46 500 cartridge oil filter. See TOA19001 for a inexpensive tool to loosen and tighten the dipstick
For post 1989 V35, V50 and V65 models use SIA27300 .
NB Packaging may vary. For an oil change we also recommend 1x ENA90444 (Oil filter cover O ring), 1 x SIA10070 (large sump drain crush washer), 1 x SIA10900 (small sump drain crush washer) and 1 x SIA12200 (filter cover crush washer)
More than 5 in stock
19153000 GU19153000 19 15 30 00
1915 3000 1915.3000 19.15.30.00
£8.50
INC VAT
£7.08 EX VAT
Cartridge oil filter UFI 23 149 00
Fits Daytona 1000 models where filter screws into base of sump. This is an 8 sided UFI filter.
Use tool TOA41006 if your filter is located inside the sump, use tool TOA01201 if you change your oil filter without removing the sump.
You may also require SIA10070 which is the crush washer for the drain plug and ENA14036 (sump gasket).
Please note that Daytona RS and T5 Polizia use filter SIA15300
More than 5 in stock
14153000 GU14153000 14 15 30 00
1415 3000 1415.3000 14.15.30.00
£10.50
INC VAT
£8.75 EX VAT