Front crank oil seal for models with Bosch or Ducati charging systems
Also known as Guzz ref. 90402839
More than 5 in stock
90402840-Z
£9.50
INC VAT
£7.92 EX VAT
Set of ignition points (made up of two boxes of contacts)
More than 5 in stock
19709620 GU19709620 19 70 96 20
1970 9620 1970.9620 19.70.96.20
£32.60
INC VAT
£27.17 EX VAT
Pinion oil seal for rear drive box on small twins and rear wheel bearing oil seal for 850T
More than 5 in stock
90403247 GU90403247 90 40 32 47
9040 3247 9040.3247 90.40.32.47
£10.50
INC VAT
£8.75 EX VAT
Cylinder head breather pipe, head to breather box/airbox
Banjo connection at head, push fit to airbox/breather box, see ENA95990 for banjo bolt
More than 5 in stock
17159700-z 17159700 GU17159700 17 15 97 00
1715 9700 1715.9700 17.15.97.00
£13.00
INC VAT
£10.83 EX VAT
High pressure black fuel line / fuel line
Also known as Guzzi ref. 008239520800, 00823941078, GU00823952080. This high pressure fuel hose is rated to 10 Bar. Also see FUA80000 of a Y shaped connector or FUA80001 for a T shaped fuel line connector. R7 spec. E5 and E10 ethanol resistant
4 in stock
823952080
£12.00
INC VAT
£10.00 EX VAT
UFI 25 531 00 cartridge oil filter for 1989 on small block engines. See TOA19001 for a inexpensive tool to loosen and tighten the dipstick
For an oil change we also recommend 1x ENA90444 (Oil filter cover O ring), 1 x SIA10070 (large sump drain crush washer), 1 x SIA10900 (small sump drain crush washer) and 1 x SIA12200 (filter cover crush washer). Some 750 XPA models use SIA19530, we advise you to check your old filter before ordering. Also known as Guzzi ref. 2A000633
More than 5 in stock
27153085 GU27153085 27 15 30 85
2715 3085 2715.3085 27.15.30.85
£9.50
INC VAT
£7.92 EX VAT
Stainless steel tool for removing Bosch alternator rotor. Will also fit Saprisa.
Simply screw in until the rotor pops off
4 in stock
Also fits Benelli Sei 900 (Series 2)
£6.60
INC VAT
£5.50 EX VAT
Stainless steel exhaust stud kit consisting of 4 x studs, 4 x dome head nuts, 4 x wavy washers and 4 x flat washers
On pre-1998 models we recommend combining with a pair of new exhaust polished aluminium flanges - EXA30032
More than 5 in stock
96508040 GU96508040 96 50 80 40
9650 8040 9650.8040 96.50.80.40
£21.00
INC VAT
£17.50 EX VAT
M12 pivot bolt kit for brake and gear lever pivots on Tonti framed models. Kit consists of 1 M12 bolt (with hex head and slotted other end), wavy washer, flat washer and half nut
Beautifully made to enhance the appearance of your bike, also cheaper than OE non stainless parts. Guzzi parts refs: 30252360, 98073660, 95100409, 92701120, 17252350. Does not fit G5
More than 5 in stock
98053660-z 98053660 GU98053660 98 05 36 60
9805 3660 9805.3660 98.05.36.60
£17.50
INC VAT
£14.58 EX VAT
M20 gearbox and drive box filler plug (big twins), drive box level plug (small twins), also used for cylinder head bolt
See ACA12600 for aluminium alternative that can be undone by hand. Includes recess for O ring ENA90203
More than 5 in stock
12022600 GU12022600 12 02 26 00
1202 2600 1202.2600 12.02.26.00
£17.50
INC VAT
£14.58 EX VAT