Inlet Valve
41mm diameter. Also known as Guzzi ref. 29036050
2 in stock
13036000 GU13036000 13 03 60 00
1303 6000 1303.6000 13.03.60.00
£27.10
INC VAT
£22.58 EX VAT
Pair of black steel brackets for mounting the nose cowling FAA14575
Requires a hex head bolt for the headlight fixing e.g. SSA08016 (depending on headlight)
2 in stock
14578651-z 14578651 GU14578651 14 57 86 51
1457 8651 1457.8651 14.57.86.51
£39.00
INC VAT
£32.50 EX VAT
Stainless steel braided hose oil lines for heads on square barrel models. See ENA14662 if you also need threaded link to cylinder head
Always replace crush washers (SIA12200 x 2 and SIA10900 x 2) when replacing oil lines, you may also require our banjo bolt ENA95990. Also known as Guzzi ref. 01153600 and 01153602
5 in stock
14153660 GU14153660 14 15 36 60
1415 3660 1415.3660 14.15.36.60
£53.00
INC VAT
£44.17 EX VAT
Sebac fork damper, standard damping rate
Also known as Guzzi ref. 18526460. See OIA01001 for ATF (used in place of fork oil)
4 in stock
14526455-z 14526455 GU14526455 14 52 64 55
1452 6455 1452.6455 14.52.64.55
Also fits Benelli Sei 900
£27.90
INC VAT
£23.25 EX VAT
Sebac fork damper, standard damping rate
See OIA01001 for ATF (used in place of fork oil)
4 in stock
14526407-z 14526407 GU14526407 14 52 64 07
1452 6407 1452.6407 14.52.64.07
£32.00
INC VAT
£26.67 EX VAT
Fuel pipe assembly including 'x' crossover piece
See FUA00004 for pipe clips. Can also be used in place of Guzzi ref. 12106501 on Loop frame models if cut to length
More than 5 in stock
29106500-z 29106500 GU29106500 29 10 65 00
2910 6500 2910.6500 29.10.65.00
Also fits Guzzi V7 Special, V7 700
£20.00
INC VAT
£16.67 EX VAT
Nut for clutch centre gear CLA30810, fits on gearbox input shaft
See TOA14903 for special tool
3 in stock
93601022-z 93601022 GU93601022 93 60 10 22
9360 1022 9360.1022 93.60.10.22
£10.00
INC VAT
£8.33 EX VAT
Complete (rev counter) tacho cable
We advise you to measure your existing cable before ordering in case you have a non standard set up.
More than 5 in stock
19768100-z 19768100 GU19768100 19 76 81 00
1976 8100 1976.8100 19.76.81.00
£12.50
INC VAT
£10.42 EX VAT
This adjustable fuelling modifier uses the lambda sensor signal to the ECU. By modifying that signal it achieves an improvement in low and midrange throttle response. Comes with wiring harness and instruction manual, installation is simple and does not require any specialist tools. Suitable for all single throttle body V7, V9 and V85 TT models.
Rapid Bike EASY: A base level simple plug and play modulator equipped with a microprocessor managing the lambda sensor signal to optimize the air/fuel ratio, improve the engine efficiency and eliminate power gaps typical of the low and medium rpm range.
See installation instructions here.
1 in stock
£149.00
INC VAT
£124.17 EX VAT
This handlebar riser kit moves the handlebars up by 35mm resulting in much improved comfort. Finished in black, this is a high quality Italian engineered kit. For yokes with 32-35mm clamp bolt centres
Kit contains fitting instructions, zinc finish bolts, bolt head plugs and risers. Normally this kit can be fitted without modifying your brakelines or control cables.
Improve riding comfort with this riser kit
1 in stock
£45.00
INC VAT
£37.50 EX VAT