The BoosterPlug is an effective and cost efficient way to cure the fuelling problems common to all modern fuel injected Guzzi's.
Plugging directly into the wiring harness using original connectors, with no cutting or splicing required, installation takes less than ten minutes.
The BoosterPlug features a unique technology to provide your bike with a controlled fuel enrichment in all ambient temperature situations. No other Plug and Play device does this. A richer mixture is provided only when needed i.e at low RPMs and when accelerating. On open roads at a constant speed the Boosterplug sits idle to keep fuel consumption low.
Make your bike run as it should have done from the factory!
This part is due back in stock soon, call 01484 841395 to reserve yours
£129.00
INC VAT
£107.50 EX VAT
Top end gasket and seal set containing rocker cover, base, head and exhaust gaskets plus top end O rings
Top end gasket set for one cylinder. Inlet manifold gasket ENA27155 available separately
2 in stock
£27.00
INC VAT
£22.50 EX VAT
Top end gasket and seal set containing rocker cover, base, head and exhaust gaskets plus cylinder base O ring
Top end gasket set for one cylinder. Inlet manifold gaskets available separately
This part is due back in stock soon, call 01484 841395 to reserve yours
£20.00
INC VAT
£16.67 EX VAT
Screw kit containing 28 replacement stainless steel socket cap bolts for timing cover, inlet manifolds and sump pan. Only one kit required per engine. See SSA87983 and SSA89291 for special rocker cover screw kits
To ensure you can easily release these fasteners in years to come we recommend wiping each fastener with copper grease (OIA11070).
Add a bit of sparkle to your V7!
More than 5 in stock
£12.00
INC VAT
£10.00 EX VAT
Top end gasket and seal set containing rocker cover, base, head and exhaust gaskets plus cylinder base O ring
Top end gasket set for one cylinder. Inlet manifold gaskets available separately
1 in stock
£20.00
INC VAT
£16.67 EX VAT
Full service kit containing 1 x UFI oil filter, 1 x UFI air filter, 2 x NGK CPR8EB-9 spark plugs, crush washers and filter cover O ring to complete a service on your bike
Save £'s by buying everything in a service kit
Oils and lubricants available separately. The oils you need are 2 x OIA01051 + 1 x OIA08196 + 1 x OIA08193. See FUA01090 for fuel filter
This part is due back in stock soon, call 01484 841395 to reserve yours
£49.00
INC VAT
£40.83 EX VAT
Exhaust stud kit consisting of 4 x titanium studs, 4 x stainless dome head nuts and 4 x stainless wavy washers
The mild steel exhaust studs fitted to modern Guzzis are notorious for corroding in place. Replace yours now with these corrosion resistant parts to ensure you can remove your exhaust in years to come
More than 5 in stock
1A003632R
£22.00
INC VAT
£18.33 EX VAT
1 litre of Agip SAE 10W fork oil. Eni Fork Oil 10W is a product designed for the motorcycle industry designed and developed for use in forks and shock absorbers, suitable for both road and off-road use. The product is part of the Fork Oil series, which includes products with a different viscosity gradient to be selected in relation to the manufacturer's requirements and/or the damping action desired. It is also possible to obtain intermediate grades by mixing with other Fork Oil grades.
As recommended by Guzzi. One litre will refill both forks on most models, check your manual for exact quantity required. 5W also available, use a combination of 5W and 10W to tune your damping more precisely
Eni Fork Oil 10W is equipped with appropriate rheological features such as low temperature fluidity, high viscosity index and a very low sliding point, which results in smooth and uniform suspension behavior in a wide range of temperatures.
This product is characterized by high anti-wear properties, which ensure high protection and long service life to the lubricating parts.
The corrosion-resistant properties of Eni Fork Oil 10W allow effective protection of surfaces against corrosive phenomena.
Eni Fork Oil 10W has the necessary properties for the correct operation of the lubricated equipment, such as low foaming, low air retention, stability in hot conditions, and compatibility with rubber materials (gaskets).
Please note this part CANNOT be posted outside of the UK mainland area. ENI oils were previously sold under the AGIP name
More than 5 in stock
GU30530527
£14.00
INC VAT
£11.67 EX VAT
1 litre of fully synthetic Eni I-Ride Scooter 10W-40. Eni i-Ride scooter 10W-40 is a synthetic technology lubricant designed to lubricate 4-stroke engines fitted in scooters. Its formulation makes it suitable for use in engines cooled either with coolant or air.
The excellent features of this product make it suitable for use in the most stressed motors, also equipped with Start & Stop systems.
The special formulation of Eni i-Ride scooter 10W-40 is able to ensure, due to the excellent lubrication, the best engine protection in all operating conditions, even the most extreme ones.
The formulation of Eni i-Ride scooter 10W-40 is developed to perform an effective control of deposits formation.
The components present in the formulation have been carefully selected to maintain their properties even under operating conditions characterized by high temperatures.
Surpasses API SJ, JASO MA and MA2. ENI oils were previously sold under the AGIP name
More than 5 in stock
£8.00
INC VAT
£6.67 EX VAT
Full service kit containing 1 x UFI oil filter, 1 x UFI air filter, crush washer and filter cover O ring, drain and level plug seals to complete a service on your bike
Save £'s by buying everything in a service kit
Guzzi approved ENI oils and lubricants available separately. The oils you need are 2 x OIA01051 for the engine or save time and money by ordering our service oil kit OIA85001. See SIA85888 for the long life spark plugs
4 in stock
£23.00
INC VAT
£19.17 EX VAT