
Shop headings: New Spares | Used Spares | Accessories | Brands

Pair of replacement anodised alloy pistons for Brembo F05 (P5) calipers. These also fit Grimeca calipers with 32mm pistons
Also used on some Laverdas. BRA19301 for alternative part in stainless steel
5 in stock 19652300 GU19652300 19 65 23 00
1965 2300 1965.2300 19.65.23.00
Also fits Benelli 250 TS, Ducati Pantah 500SL
Dimensions:
32mm OD
£32.00
INC VAT
£26.67 EX VAT ![]()

Inlet manifold rubber. Fits between exhaust manifold on cylinder head and carb
Also known as Guzzi ref. 19114360. 31114060. Use clip SSA32957
More than 5 in stock31114383-z 31114383 GU31114383 31 11 43 83
3111 4383 3111.4383 31.11.43.83
Dimensions:
35mm internal diameter x 50mm outer diameter x 36mm
£12.50
INC VAT
£10.42 EX VAT ![]()

Riders footpeg rubber, black with chamfered underside
4 in stock28443201-z 28443201 GU28443201 28 44 32 01
2844 3201 2844.3201 28.44.32.01
Dimensions:
95mm x 43mm x 40m overall. Peg hole diameter 19mm
£7.60
INC VAT
£6.33 EX VAT ![]()

Gearbox return spring
Selector spring also known as Guzzi ref. 32238210, 14238200, 14238201, 28238260. This 3 coil spring is a Guzzi update to the 4 coil spring used on some small twins
5 in stock 28238261 GU28238261 28 23 82 61
2823 8261 2823.8261 28.23.82.61
Dimensions:
64mm x 42mm overall
£6.20
INC VAT
£5.17 EX VAT ![]()

Fuel level sender for fuel tank
2 pin connector block. Use seal TAA90103 with this part
2 in stock29103050-z 29103050 GU29103050 29 10 30 50
2910 3050 2910.3050 29.10.30.50
Dimensions:
15mm male thread
£29.30
INC VAT
£24.42 EX VAT ![]()

Black solenoid cover for Bosch starter motor
2 in stock19733350-z 19733350 GU19733350 19 73 33 50
1973 3350 1973.3350 19.73.33.50
£11.70
INC VAT
£9.75 EX VAT ![]()

Choke cable for remote left cylinder mounted choke, fits both carbs
Alternative for Le Mans models that were fitted with the shorter version of the choke cable. We advise you to measure your existing cable before ordering in case you have a non standard set up. See CAA28133 for long version.
2 in stock28133500-Z
Dimensions:
320mm outer cable, 100mm free length, 2.7mm barrel nipple, 2.7mm barrel nipple
£7.50
INC VAT
£6.25 EX VAT ![]()

Clutch cable for pre 1988 models with left hand switchgear integrated into clutch lever clamp
1 in stock28093060-z 28093060 GU28093060 28 09 30 60
2809 3060 2809.3060 28.09.30.60
Dimensions:
1265mm outer length, 83mm free length, 9.9mm barrel nipple, 9.9mm barrel nipple
£17.50
INC VAT
£14.58 EX VAT ![]()

Thottle cable, runs from twistgrip to carb
We advise you to measure your existing cable before ordering in case you have a non standard set up.
4 in stock 19117580 GU19117580 19 11 75 80
1911 7580 1911.7580 19.11.75.80
Dimensions:
1020mm outer length, 96mm free length, 5.7mm barrel nipple, 2.7mm barrel nipple
£10.00
INC VAT
£8.33 EX VAT ![]()

Complete cast side stand with springs, pivot and mounting bracket finished in black. This stand is the original flip up / self retracting type
Bolts to engine mounting bolt at front of lower framerail, check that you have a long enough front engine mounting bolt for this sidestand to fit on to. This can be fitted to other Tonti frame models (e.g. Le Mans 1000). See FRA28162 for bracket that enables this stand to be mounted near the rider's footrest using the gearbox mounting bolt.
1 in stock17432060-z 17432060 GU17432060 17 43 20 60
1743 2060 1743.2060 17.43.20.60
Dimensions:
250mm from pivot to base of stand
£99.50
INC VAT
£82.92 EX VAT ![]()