
Shop headings: New Spares | Used Spares | Accessories | Brands

Fine thread screw in brakelight switch for linked system proportioning valve or splitter. See ELA12735 for rubber cap
Stop light switch also known as Guzzi ref. 63657000
5 in stock 79654116 GU79654116 79 65 41 16
7965 4116 7965.4116 79.65.41.16
Also fits Ducati 350-500 Twin, Ducati 350-500 Twin GTV, Ducati 350-500 Twin Sport, Ducati 500 SL Pantah, Ducati 500 Sport Desmo, Ducati 600 SL Pantah, Ducati 750 GT/Sport Köwe, Ducati 750 Paso (1984-1992), Ducati 750 Sport, Ducati 750/900 SS Köwe, Ducati 750 F1/Laguna Seca, Ducati 860/900 GTS, Ducati 900 Darmah, Ducati 900 MHR-I, Ducati 900 SS (1990), Ducati 906 Paso (1988), Ducati 1000 MHR-2/S2
Dimensions:
M10 fine thread
£22.00
INC VAT
£18.33 EX VAT ![]()

Sebac fork damper, standard damping rate
Also known as Guzzi ref. 18526460. See OIA01001 for ATF (used in place of fork oil)
4 in stock14526455-z 14526455 GU14526455 14 52 64 55
1452 6455 1452.6455 14.52.64.55
Also fits Benelli Sei 900
£40.00
INC VAT
£33.33 EX VAT ![]()

Set of ignition points (made up of two boxes of contacts)
More than 5 in stock 19709620 GU19709620 19 70 96 20
1970 9620 1970.9620 19.70.96.20
£39.50
INC VAT
£32.92 EX VAT ![]()

Front brake cable
Other Nuovo Falcone parts available, please enquire
1 in stock 10625400 GU10625400 10 62 54 00
1062 5400 1062.5400 10.62.54.00
Dimensions:
1175mm outer length, 120mm free length, 9.1mm barrel nipple, 10mm barrel nipple
£19.00
INC VAT
£15.83 EX VAT ![]()

New type clutch friction plate for models with deep splines with deep splined centre
2 plates required- thicker side of each friction plate should face transmission.
Also known as Guzzi ref. 30084410, 03084400, 29084450
V11 Tenni, Rosso Mandello and Scura have a single plate clutch which uses a different friction plate (unfortunately out of production)
These can be fitted to earlier 850 and 1000 models if the early shallow splined clutch centre is replaced with the later deep splined type. See our kit CLA20302 to update early 850/1000 models. Clutch plate alignment tool also available, see TOA30510
4 in stock 05084430 GU05084430 05 08 44 30
0508 4430 0508.4430 05.08.44.30
£59.00
INC VAT
£49.17 EX VAT ![]()

Manual left hand petrol tap with nut. On, Off and Reserve settings.
Will also fit most other Moto Guzzi tanks from 1976 to 1991, these can be used to replace discontinued electric taps but please measure first and check you have space for outlet pipe
More than 5 in stock65105400-z 65105400 GU65105400 65 10 54 00
6510 5400 6510.5400 65.10.54.00
Also fits Laverda Jota. Can be used on Morini 350 Sport and Morini 350 Strada as replacement for electronic fuel tap
Dimensions:
M16 x 1 threaded section, 8mm fuel spigot
£12.60
INC VAT
£10.50 EX VAT ![]()

Manual right hand petrol tap with nut. On, Off and Reserve settings.
Will also fit most other Moto Guzzi tanks from 1976 to 1991, these can be used to replace discontinued electric taps but please measure first and check you have space for outlet pipe
More than 5 in stock65105401-z 65105401 GU65105401 65 10 54 01
6510 5401 6510.5401 65.10.54.01
Also fits Laverda Jota
Dimensions:
M16 x 1 threaded section, 8mm fuel spigot
£12.60
INC VAT
£10.50 EX VAT ![]()

Round 12v two pin flasher relay
See FRA17720 for rubber mount, item may look different to this please take into consideration before ordering.
More than 5 in stock 17750520 GU17750520 17 75 05 20
1775 0520 1775.0520 17.75.05.20
Dimensions:
32mm diameter
£7.60
INC VAT
£6.33 EX VAT ![]()

Large rear battery strap with metal clip
4 in stock14705500-z 14705500 GU14705500 14 70 55 00
1470 5500 1470.5500 14.70.55.00
Dimensions:
285mm x 45mm x 8mm overall
£11.00
INC VAT
£9.17 EX VAT ![]()

Air filter, flat paper cartridge type
See SIA10425 for a reusable performance air filter
More than 5 in stockAP8104242
Dimensions:
115mm x 155mm x 28mm
£12.00
INC VAT
£10.00 EX VAT ![]()