Fork dust cover for Marzocchi M1R fork stanchion

Also used on Ducati Paso 750 (1982-1992), 906 Paso and 907 IE

 Availability varies on this part, check availability

 30524500 GU30524500 30 52 45 00
 3052 4500 3052.4500 30.52.45.00

Complete twin bleed F09 (P9) front left hand (when mounted behind fork leg, otherwise use as RH) replica Brembo brake caliper. Also rear caliper (when mounted above and behind rear wheel spindle). Supplied with bleed nipples, dust cover, pins and spring. This can replace the P9 rear caliper as fitted to a 1000 SP, or can be used as a performance upgrade to replace the smaller piston P8 caliper fitted as standard to many Guzzis. Please see Guzziology for advice on how to perform this conversion.

Brake pads not included- see BRA33204

 Availability varies on this part, check availability

Left hand fuel tap with fuel level sensor

Two pin connector block for fuel sender

 Availability varies on this part, check availability

 31105460 GU31105460 31 10 54 60
 3110 5460 3110.5460 31.10.54.60

Tool for crankshaft timing sprocket nut, this is a superior design tool intended for repeated use. Use for clutch centre nut on V11 Sport. Will not reach timing sprocket nut on models with Ducati charging system.

Also fits swingarm spindle nut on Stelvio.

Half inch socket drive

 Availability varies on this part, check availability

 18927651 GU18927651 18 92 76 51
 1892 7651 1892.7651 18.92.76.51

Pair of organic EBC FA256 rear brake pads for Hengtong caliper used on 2012 on models

Twin pin fitting. Pre 2012 V7 models use a different brake pad with only one pad pin hole. Also known as Guzzi ref 2R000248

 1 in stock

AP8133798

Rebuild kit for Brembo rear caliper. This is a comprehensive overhaul kit containing dust seals, fluid seals, o ring, bleed nipple, and dust cap

Caliper seal kit

 This part is available by special order, request a quote