Complete fuel pump assembly including mounting plate, gasket and fuel filter

Also known as Guzzi ref. 978826 88724

 This part is available by special order, request a quote

 03107270 GU03107270 03 10 72 70
 0310 7270 0310.7270 03.10.72.70

Discontinued by Bosch, superceded to 97729R. Also see ELA05731 for new replacement part or ELC05730 for reconditioned alternative

 This part is available by special order, request a quote

 05730730 GU05730730 05 73 07 30
 0573 0730 0573.0730 05.73.07.30

Complete electronic ignition kit containing alternator mounted ignition pickup, fittings and amplifier unit. Works with 12 volt 3 Ohm coils ELA14500 (big twins) and can be used to replace Digiplex on models with Ducati charging systems where the bike is converted to carburettors. This kit is just an ignition system, it will not control fuelling. The pickups for this kit are mounted on the alternator stator. Supplied with instructions in German with wiring diagrams.

2 year warranty on Sachse ignition kits

Once fitted no further adjustment should be necessary. Preloaded with nine ignition curves, two of which are designed for twin plugged bikes. See this link for fitting instructions. Some bikes may need at least one additional spacer to allow enough clearance for alternator cover to fit once pickup is fitted. Note that if you are replacing a Digiplex system you will also need to replace your 'square' coils with higher impedance 12 volt coils e.g. ELA14500

 This part is available by special order, request a quote

Ducati regulator rectifier for models fitted with the Ducati charging system

Connections: 2 x yellow male bullet, 1 x white female bullet, 1 x black male bullet, 1 x red male bullet. See ELA28739 for a less expensive alternative

 This part is due back in stock soon, call 01484 841395 to reserve yours

37703805-z 37703805 GU37703805 37 70 38 05
 3770 3805 3770.3805 37.70.38.05

Brand new genuine Valeo starter motor and solenoid suitable as a direct replacement for Guzzi Valeo and Bosch 8 or 9 teeth starter motors. You may need to fit hex headed neutral switch bolts on some pre 1990 models to make room for the solenoid. Our part number for the bolt is SSA06016
Please note that this item may be fitted to Loop frame models with some modifications as described in Guzziology, also see https://www.thisoldtractor.com/moto_guzzi_loopframe_starter_-_how_to_replace_the_magneti_marelli_starter_with_a_valeo.html for advice on this upgrade.

This is a genuine Valeo starter made in the EU- please do not confuse with the cheap Chinese copies that sometimes appear on eBay.

Supercedes Guzzi refs. 12730705, 14730554 and 14730705

Please note you can get a discount of £30 on this item if you part exchange your existing faulty starter motor. See ELA30837 for less expensive alternative part

 This part is due back in stock soon, call 01484 841395 to reserve yours

 30730711 GU30730711 30 73 07 11
 3073 0711 3073.0711 30.73.07.11

Ducati type alternator stator

300W output, doesn't include rotor / magnet. Also known as Guzzi ref. 30712460

 1 in stock

 37712405 GU37712405 37 71 24 05
 3771 2405 3771.2405 37.71.24.05

12 volt coil used on late Guzzis

Sometimes referred to as the 'square coil', two required per bike. See ELA00001 for crimp on HT lead connector

 This part is due back in stock soon, call 01484 841395 to reserve yours

 30716500 GU30716500 30 71 65 00
 3071 6500 3071.6500 30.71.65.00

Ducati type regulator rectifier for models fitted with the later 350W Ducati charging system. Supplied wired with 1 x 4 pin and 1 x 2 pin block connector

Also known as Guzzi ref. 03703870. Note that some models have a different white connector block, if you have this connector then you will need to modify the connector to fit. This includes the mk 1 V7 Special and V7 Stone

 1 in stock

 32703810 GU32703810 32 70 38 10
 3270 3810 3270.3810 32.70.38.10

Motobatt quadflex 30Ah battery. Quadflex technology means you have two positive and two negative threaded terminals allowing maximum flexibility when installing. This powerful battery produces a massive 390 cranking amps, and is rated at 32 ah.

These sealed absorbed glass matt batteries have been used in military and off road applications for many years.
They offer increased lifespan, higher vibration resistance and electrical performance. This battery is also leak, vibration and spill proof if installed correctly.
Supplied fully charged and ready to fit.

NB This battery must not be trickle charged or charged using a traditional manual charger, AGM batteries require a smart charger - we recommend ACA96000
For more information on charging AGM batteries see these FAQ's.

This is a better value replacement for the Odyssey PC925 battery. Replaces Guzzi refs. 14704550, 18704550, 28704550, 28704545, 28704551, 28704552, 14704551, 14704500 and 14704505

One year warranty on all our Motobatt batteries.

Slightly taller than original loop frame battery so you may need to make some modification to retaining bracket

Please note this part CANNOT be posted outside of the UK mainland area

 1 in stock

03704540-z 03704540 GU03704540 03 70 45 40
 0370 4540 0370.4540 03.70.45.40

Reconditioned Valeo starter motor and solenoid in black and silver finish. Professionally reconditioned and sold with a 12 month guarantee. This is a suitable replacement for Bosch 8 or 9 tooth Guzzi starter motors. Minor modification may be required on some pre 1990 models to make room for the solenoid. Please note that this item may be fitted to Loop frame models with some modifications as described in Guzziology. See , see this link for the modifications required to fit a Valeo starter to a 4 speed model.

This is an exchange only item, we can supply these before receiving your exchange unit subject to a refundable deposit so you can keep your bike on the road. See ELC10737 for the refundable deposit. Send your old starter motor to our registered address. NB In case of starter motor problems do not tap the casing as this will certainly cause it to fail. See SSA08075 for mounting bolts. Also known as Guzzi ref. 30730710
Do not remove second nut from terminal posts when fitting - this nut is required to hold the terminal in place

Supercedes Guzzi refs. 12730705, 14730554 and 14730705

 30730711 GU30730711 30 73 07 11
 3073 0711 3073.0711 30.73.07.11