Rotational oil seal for crownwheel carrier in drive box on post 1974 big twins. Front crank oil seal on loop frame models

Also known as Guzzi ref. 90403850 and used on 850 GT and loop frame models for front crank oil seal ( 90403851 )

 90413850 GU90413850 90 41 38 50
 9041 3850 9041.3850 90.41.38.50

Dimensions:
38mm x 50 mm x 7mm

Rotor bolt for Bosch alternator

Not previously available from Guzzi. May also be used on a Saprisa alternator

 14712459 GU14712459 14 71 24 59
 1471 2459 1471.2459 14.71.24.59

Dimensions:
M8 x 50mm

Replacement starter motor for 2006 on models. Also known as 97729R

This is a less expensive aftermarket replacement for the OE starter.
Not interchangeable with Valeo and Bosch starters from earlier models. Get a £20 discount on this part if you send us your faulty but reconditionable starter motor

 05730730 GU05730730 05 73 07 30
 0573 0730 0573.0730 05.73.07.30

This adjustable fuelling modifier uses the lambda sensor signal to the ECU. By modifying that signal it achieves an improvement in low and midrange throttle response. Comes with wiring harness and instruction manual, installation is simple and does not require any specialist tools. Suitable for all single throttle body V7, V9 and V85 TT models.

Rapid Bike EASY: A base level simple plug and play modulator equipped with a microprocessor managing the lambda sensor signal to optimize the air/fuel ratio, improve the engine efficiency and eliminate power gaps typical of the low and medium rpm range.

See installation instructions here.

Head Gasket

 976052 MG976052

Dimensions:
95mm ID

Threaded adapter base for oil pressure switches

See ENA12640 for crush washer

 887123 MG887123

Black handlebar mounted mirror. Conventional M10 thread, head is threaded for left or right hand fitment.

Supercedes BUMM mirror HAA36021W. See ACA00101 for a black mirror extender kit to extend the reach of this mirror.

Dimensions:
M10 conventional thread, approx. 240mm reach to far edge of mirror, mirror 110mm diameter

High pressure internal fuel line / submersible fuel line, suitable for immersion in petrol. You will need to cut this to length according to your model

Suitable for modern fuel. 100% ethanol resistant. High pressure fuel hose. This is designed for use submerged in petrol inside the fuel tank. See FUA00004 for pipe clips

Brush kit for overhauling Valeo starter motor

Check whether you have a Valeo or Bosch starter before ordering