Carb gasket kit / rebuild kit for Dellorto VHB29, VHB30, VHB24 and VHB26 carbs

Carb overhaul kit, fuel filter FUA60888 and float bowl seal FUA90001 available separately to this seal kit. As this kit is intended for several different carbs you may have gaskets or O rings remaining after rebuilding. More information on rebuilding your VHB carb can be found here.

 More than 5 in stock

 17939950 GU17939950 17 93 99 50
 1793 9950 1793.9950 17.93.99.50

Oil pressure sender, M12 thread, male bullet connector

Supercedes Guzzi no. 12768700. Some small twins also require adapter 19055800 (or ELA19720 can be fitted in place of this switch). Check which type your small twin uses before replacing.

See ENA12640 for replacement crush washer if required

 More than 5 in stock

 17768750 GU17768750 17 76 87 50
 1776 8750 1776.8750 17.76.87.50

Rear crankcase oil seal or rear main oil seal.

Fits Nevada 750 up to engine LT017877 and Nevada 350 to engine PC053625. Also known as Guzzi ref. 90405368. We recommend replacing the rear crank oil seal when replacing the clutch

 More than 5 in stock

90405367-z 90405367 GU90405367 90 40 53 67
 9040 5367 9040.5367 90.40.53.67

Rotational oil seal for crownwheel carrier in drive box on post 1974 big twins. Front crank oil seal on loop frame models

Also known as Guzzi ref. 90403850 and used on 850 GT and loop frame models for front crank oil seal ( 90403851 )

 More than 5 in stock

 90413850 GU90413850 90 41 38 50
 9041 3850 9041.3850 90.41.38.50

Cartridge oil filter UFI 23 149 00

Fits Daytona 1000 models where filter screws into base of sump. This is an 8 sided UFI filter.
Use tool TOA41006 if your filter is located inside the sump, use tool TOA01201 if you change your oil filter without removing the sump.

You may also require SIA10070 which is the crush washer for the drain plug and ENA14036 (sump gasket). Please note that Daytona RS and T5 Polizia use filter SIA15300

 More than 5 in stock

 14153000 GU14153000 14 15 30 00
 1415 3000 1415.3000 14.15.30.00

Chromed fork stanchion

 2 in stock

39525401-z 39525401 GU39525401 39 52 54 01
 3952 5401 3952.5401 39.52.54.01

Also fits Benelli 504

Dellorto 8.5g float with tang for needle valve

Most Guzzi big twins originally had 10g floats- see FUA14001

 3 in stock

 14933000 GU14933000 14 93 30 00
 1493 3000 1493.3000 14.93.30.00

Standard grey tinted screen for headlamp fairing. Includes screen edge trim.

Fitting kits available separately. Screen fasteners are FAA98417 x 3, FAA04001 x 6, FAA90035 x 3, FAA92104 x 3

 2 in stock

14577250-z 14577250 GU14577250 14 57 72 50
 1457 7250 1457.7250 14.57.72.50

Gearbox locknut, one nut fitted to each end of the layshaft

 1 in stock

 10054100 GU10054100 10 05 41 00
 1005 4100 1005.4100 10.05.41.00

Black rubber UJ boot / gaiter

See TRA23101 for clip

 2 in stock

23548080-z 23548080 GU23548080 23 54 80 80
 2354 8080 2354.8080 23.54.80.80