
Shop headings: New Spares | Used Spares | Accessories | Brands

New type clutch friction plate for models with deep splines with deep splined centre
2 plates required- thicker side of each friction plate should face transmission.
Also known as Guzzi ref. 30084410, 03084400, 29084450
V11 Tenni, Rosso Mandello and Scura have a single plate clutch which uses a different friction plate (unfortunately out of production)
These can be fitted to earlier 850 and 1000 models if the early shallow splined clutch centre is replaced with the later deep splined type. See our kit CLA20302 to update early 850/1000 models. Clutch plate alignment tool also available, see TOA30510
4 in stock 05084430 GU05084430 05 08 44 30
0508 4430 0508.4430 05.08.44.30
£59.00
INC VAT
£49.17 EX VAT ![]()

Complete (rev counter) tacho cable
We advise you to measure your existing cable before ordering in case you have a non standard set up.
More than 5 in stock19768100-z 19768100 GU19768100 19 76 81 00
1976 8100 1976.8100 19.76.81.00
Dimensions:
588mm
£12.95
INC VAT
£10.79 EX VAT ![]()

5 pin 12 volt Bosch relay suitable for starter, lights, indicator, flasher and horn applications
Supercedes Guzzi ref. 12732500. Equivalent to 28732500 but with mounting bracket
4 in stock19732500-z 19732500 GU19732500 19 73 25 00
1973 2500 1973.2500 19.73.25.00
Dimensions:
55mm x 33mm x 26mm overall
£15.20
INC VAT
£12.67 EX VAT ![]()

Swingarm bearing oil seal
Dust seal for swingarm bearing
More than 5 in stock 90403040 GU90403040 90 40 30 40
9040 3040 9040.3040 90.40.30.40
Dimensions:
40mm OD
£7.50
INC VAT
£6.25 EX VAT ![]()

Fine thread screw in brakelight switch for linked system proportioning valve or splitter. See ELA12735 for rubber cap
Stop light switch also known as Guzzi ref. 63657000
5 in stock 79654116 GU79654116 79 65 41 16
7965 4116 7965.4116 79.65.41.16
Also fits Ducati 350-500 Twin, Ducati 350-500 Twin GTV, Ducati 350-500 Twin Sport, Ducati 500 SL Pantah, Ducati 500 Sport Desmo, Ducati 600 SL Pantah, Ducati 750 GT/Sport Köwe, Ducati 750 Paso (1984-1992), Ducati 750 Sport, Ducati 750/900 SS Köwe, Ducati 750 F1/Laguna Seca, Ducati 860/900 GTS, Ducati 900 Darmah, Ducati 900 MHR-I, Ducati 900 SS (1990), Ducati 906 Paso (1988), Ducati 1000 MHR-2/S2
Dimensions:
M10 fine thread
£22.00
INC VAT
£18.33 EX VAT ![]()

Output oil seal for drive box
This oil seal fits output side of bevel box
More than 5 in stock90407085-z 90407085 GU90407085 90 40 70 85
9040 7085 9040.7085 90.40.70.85
Dimensions:
70mm x 85mm x 8mm
£14.00
INC VAT
£11.67 EX VAT ![]()

Manual right hand petrol tap with nut. On, Off and Reserve settings.
Will also fit most other Moto Guzzi tanks from 1976 to 1991, these can be used to replace discontinued electric taps but please measure first and check you have space for outlet pipe
More than 5 in stock65105401-z 65105401 GU65105401 65 10 54 01
6510 5401 6510.5401 65.10.54.01
Also fits Laverda Jota
Dimensions:
M16 x 1 threaded section, 8mm fuel spigot
£12.60
INC VAT
£10.50 EX VAT ![]()

Manual left hand petrol tap with nut and filter. On, Off and Reserve settings.
Point on lever faces back in off position. Can be used to replace electronic fuel solenoid valve 37105305
More than 5 in stock17105461-z 17105461 GU17105461 17 10 54 61
1710 5461 1710.5461 17.10.54.61
Dimensions:
16mm threaded section, 8mm fuel pipe spigot
£12.60
INC VAT
£10.50 EX VAT ![]()

Air filter, flat paper cartridge type
See SIA10433 for a reusable K & N air filter
More than 5 in stockAP8104329
Dimensions:
180mm x 125mm x 38mm
£11.00
INC VAT
£9.17 EX VAT ![]()

Rear crankcase oil seal or rear main oil seal.
Fits Nevada 750 up to engine LT017877 and Nevada 350 to engine PC053625. Also known as Guzzi ref. 90405368. We recommend replacing the rear crank oil seal when replacing the clutch
More than 5 in stock90405367-z 90405367 GU90405367 90 40 53 67
9040 5367 9040.5367 90.40.53.67
Dimensions:
68mm OD
£14.00
INC VAT
£11.67 EX VAT ![]()