Red lens for oblong rear light, includes clear section to illuminate number plate

Can be used to replace tail light lens on Lario and Le Mans 1000, note that this one does not have side 'wings' but is functional on these models

 1 in stock

 65741700 GU65741700 65 74 17 00
 6574 1700 6574.1700 65.74.17.00

Stainless steel braided hose oil lines for heads on square barrel models. See ENA14662 if you also need threaded link to cylinder head

Always replace crush washers (SIA12200 x 2 and SIA10900 x 2) when replacing oil lines, you may also require our banjo bolt ENA95990. Also known as Guzzi ref. 01153600 and 01153602

 4 in stock

 14153660 GU14153660 14 15 36 60
 1415 3660 1415.3660 14.15.36.60

Full service kit containing 1 x UFI oil filter, 1 x UFI air filter, 2 x NGK B8ES spark plugs, 2 x rocker cover gaskets and all crush washers and O rings to complete a service on your bike

Save £'s by buying everything in a service kit

Oils and lubricants available separately. The oils you need are 1 x OIA11036 + 1 xOIA08194 + 1 x OIA08193 or save time and hassle by ordering service oil kit OIA19000 with your service kit.

 This part is due back in stock soon, call 01484 841395 to reserve yours

Top end gasket and seal set containing rocker cover, base, head and exhaust gaskets plus top end O rings

Top end gasket set for one cylinder. Inlet manifold gasket ENA27155 available separately

 2 in stock

Screw kit containing 28 replacement stainless steel socket cap bolts for timing cover, inlet manifolds and sump pan. Only one kit required per engine. See SSA87983 and SSA89291 for special rocker cover screw kits

To ensure you can easily release these fasteners in years to come we recommend wiping each fastener with copper grease (OIA11070).

Add a bit of sparkle to your V7!

 More than 5 in stock

Full service kit containing 1 x UFI oil filter, 1 x UFI air filter, 2 x NGK CPR8EB-9 spark plugs, crush washers and filter cover O ring to complete a service on your bike

Save £'s by buying everything in a service kit

Oils and lubricants available separately. The oils you need are 2 x OIA01051 + 1 x OIA08196 + 1 x OIA08193. See FUA01090 for fuel filter

 This part is due back in stock soon, call 01484 841395 to reserve yours

Exhaust stud kit consisting of 4 x titanium studs, 4 x stainless dome head nuts and 4 x stainless wavy washers

The mild steel exhaust studs fitted to modern Guzzis are notorious for corroding in place. Replace yours now with these corrosion resistant parts to ensure you can remove your exhaust in years to come

 More than 5 in stock

1A003632R

1 litre of Agip SAE 10W fork oil. Eni Fork Oil 10W is a product designed for the motorcycle industry designed and developed for use in forks and shock absorbers, suitable for both road and off-road use. The product is part of the Fork Oil series, which includes products with a different viscosity gradient to be selected in relation to the manufacturer's requirements and/or the damping action desired. It is also possible to obtain intermediate grades by mixing with other Fork Oil grades.

As recommended by Guzzi. One litre will refill both forks on most models, check your manual for exact quantity required. 5W also available, use a combination of 5W and 10W to tune your damping more precisely

Eni Fork Oil 10W is equipped with appropriate rheological features such as low temperature fluidity, high viscosity index and a very low sliding point, which results in smooth and uniform suspension behavior in a wide range of temperatures.

This product is characterized by high anti-wear properties, which ensure high protection and long service life to the lubricating parts.

The corrosion-resistant properties of Eni Fork Oil 10W allow effective protection of surfaces against corrosive phenomena.

Eni Fork Oil 10W has the necessary properties for the correct operation of the lubricated equipment, such as low foaming, low air retention, stability in hot conditions, and compatibility with rubber materials (gaskets).
Please note this part CANNOT be posted outside of the UK mainland area. ENI oils were previously sold under the AGIP name

 More than 5 in stock

GU30530527

1 litre of Agip SAE 15W fork oil, lighter weight than standard on most Guzzi models. Eni Fork Oil 15W is a product designed for the motorcycle industry designed and developed for use in forks and shock absorbers, suitable for both road and off-road use.

As recommended by Guzzi. One litre will refill both forks on most models, check your manual for exact quantity required. 10W also available, use a combination of 10W and 15W to tune your damping more precisely

Please note this part CANNOT be posted outside of the UK mainland area. It is also possible to obtain intermediate grades by mixing with other Fork Oil grades. ENI oils were previously sold under the AGIP name

 More than 5 in stock

Full service kit containing 1 x UFI oil filter, 1 x UFI air filter, crush washer and filter cover O ring, drain and level plug seals to complete a service on your bike

Save £'s by buying everything in a service kit

Guzzi approved ENI oils and lubricants available separately. The oils you need are 2 x OIA01051 for the engine or save time and money by ordering our service oil kit OIA85001. See SIA85888 for the long life spark plugs

 This part is due back in stock soon, call 01484 841395 to reserve yours