Clutch pushrod seal

 90400616 GU90400616 90 40 06 16
 9040 0616 9040.0616 90.40.06.16

Dimensions:
6mm ID x 16mm OD x 7mm

Round 12v two pin flasher relay

See FRA17720 for rubber mount, item may look different to this please take into consideration before ordering.

 17750520 GU17750520 17 75 05 20
 1775 0520 1775.0520 17.75.05.20

Dimensions:
32mm diameter

Air filter, flat paper cartridge type

See SIA10433 for a reusable K & N air filter

AP8104329

Dimensions:
180mm x 125mm x 38mm

Air filter, flat paper cartridge type

See SIA10433 for a reusable K & N air filter

AP8104329

Dimensions:
180mm x 125mm x 38mm

Black solenoid cover for Bosch starter motor

19733350-z 19733350 GU19733350 19 73 33 50
 1973 3350 1973.3350 19.73.33.50

Set of ignition points (made up of two boxes of contacts)

 19709620 GU19709620 19 70 96 20
 1970 9620 1970.9620 19.70.96.20

Air filter, cylindrical paper cartridge type

See SIA10422 for a reusable K & N air filter

AP8104211

Dimensions:
128mm external diameter, x 112mm

Brembo brake master cylinder overhaul kit for handlebar, undertank (cable operated) mounted, handlebar mounted and rear PS 12 master cylinders. Contains seals, brake grease, spring and piston. PS12 handlebar master cylinder fitted to early 850 and 1000 models. PS12 rear master cylinder fitted to Nevada 750

This seal kit is also known as 082039797. NB repair kit instructions refer to rear master cylinder. To fit this to a PS12 handlebar mounted cylinder you will need to punch the old piston out using a thin drift through the hole at the banjo bolt end of the master cylinder. Carefully note the order of the ring and washer as the piston comes out and replace with components from kit. Brembo no. 110279720. See this link for help with fitting this kit

 17659352 GU17659352 17 65 93 52
 1765 9352 1765.9352 17.65.93.52

Also fits Ducati 500 SL Pantah, Ducati 350/500 Twin GTV, Ducati 350/500 SL Pantah, Benelli 500 Quattro, Benelli 504 Sport, Benelli 250 2C, Benelli 900 Sei, Laverda Montjuic, Harris F1

Dimensions:
Solid piston 12.7mm OD x 65mm

One metre of copper core HT lead, this is superior to the more commonly available carbon core lead

Sold by the metre, one metre is enough for two leads on most models with coils under the fuel tank. For models with coils under the side panel you will need two metres. See ELA14715 and ELA14714 for plug caps and ELA20001 for coil screw cap. See ELA00001 for crimp on HT lead connector

Dimensions:
100cm

Gauze sump filter, retained by ENA95006

 14152200 GU14152200 14 15 22 00
 1415 2200 1415.2200 14.15.22.00